-
Anonymous users2024-01-24There is a water tank in the toilet that can be adjusted to the speed of water intake, because the brand is different, you might as well open it yourself and study it carefully.
-
Anonymous users2024-01-23Possible Questions:
1.Insufficient water pressure in the home. Look at the speed of the faucet of the wash basin, the water pressure is not enough, the water flow is small, so the water inlet is slow.
2.The angle valve of the toilet inlet pipe is opened smaller, so the water inlet is also slow.
It is generally unlikely to be a problem with the toilet tank's fittings.
-
Anonymous users2024-01-22It seems that it was possible before.
Check step by step.
Remove the angle valve and try it. Isn't the water big.
Screw on the angle valve and try again. Is the angle valve blocked? Especially the current porcelain core valve. It's easy to block.
Then try the metal hose connection.
It's all good except for the toilet. That's a fixture problem.
Lift the float is not able to go up and down.
All of the above is no problem. That's the total water pressure.
-
Anonymous users2024-01-21There are only 2 possibilities for this scenario.
1: The inlet valve is blocked, but it is not completely blocked, 2: The water pressure is not enough, because your original speed is OK, it is estimated that the first solution is to remove the inlet pipe, remove the water inlet parts, and clean it with water.
-
Anonymous users2024-01-20One: the problem of water pressure, too small water pressure can also cause this.
Two: accessories adjustment problem, you can adjust the water inlet valve water supply switch, can be large and small, if there is no switch, is a plug, pull out the plug and re-plug the water supply pipe
-
Anonymous users2024-01-19Encountered the same problem, and haven't checked yet. From here, we know that there are many links that need to be checked: there are angle valves and inlet filters outside the water tank; Inside the tank is the floating head controlled inlet valve (I guess it's here).
Taobao above 5 15 yuan + postage is OK.
-
Anonymous users2024-01-18It is possible that the toilet inlet valve is blocked.
-
Anonymous users2024-01-17Reasons for insufficient water pressure Whether the inlet valve in the toilet tank is blocked If it is not a water pressure problem, it is recommended to replace the inlet valve with a new one.
Is it straight to ask when you buy, it should be said that this price is not expensive.
Let's clean the toilet.
Go to the supermarket and check it out, a lot. >>>More
The key is that the rubber pad (may be an engineering plastic cushion) at the water inlet can not suppress the water flow of the inlet, and a rubber pad of the same size as the water inlet can be cut and glued to the original rubber pad (may be an engineering plastic cushion) with universal tape, so as to increase the pressure of pressing the water flow of the inlet water, and the float ball will reach a certain height with the water level, and the rubber pad (may be an engineering plastic cushion) will be added by the lever to easily block the water flow of the inlet water. There is also a step to tighten the cushion by turning the screws behind the engineering plastic cushion to adjust the tightness of the cushion in a clockwise direction a few times to tighten the cushion. In this way, the problem of water leakage is solved.
The reason for the air hammer is that some places below you may be blocked, but the blockage is not bad.
This belongs to mechanical failure, that is, the accessories in the tank are not flexible caused by the activity, mainly to see whether the model of the accessories and the internal installation structure have friction with each other, adjust it, most of the plugged chains are short or the float (float) of the water valve has the phenomenon of the card owner, you will see it if you look carefully, try to see if you can't send the picture inside the water tank, it is good to analyze, in view of the limited number of answers to questions and supplementary answers, you can contact in a private message