-
Anonymous users2024-01-24The inside of the toilet is actually very simple, just a float, if the water does not come out, it may be that the float inside is broken, first release the water, and then buy a float to replace it.
-
Anonymous users2024-01-23Those small holes do not have water coming out because the inlet valve refill pipe is not properly placed, and normally, it will be inserted into the refill hole of the toilet. The function of these small holes is that when flushing, the toilet bowl can be washed, and then after the large siphon, the toilet water seal will be compensated.
So that the water seal can meet the national standard. You can look inside the toilet tank.
-
Anonymous users2024-01-22The two buttons on the top of the lid are not in place, you can adjust them yourself.
-
Anonymous users2024-01-21The water plug is not open and there is a problem with the connection.
-
Anonymous users2024-01-20Agree with 123.
The two buttons on the top of the lid are not in place, you can adjust them yourself.
1. Open the main valve to determine whether there is tap water. >>>More
Check the main valve for tap water first, and then open the lid of the water tank to check the upper and lower water, it is possible that the drain of the toilet has blocked the foreign object. See if the piston can be plugged, if you can't plug the water tank, it will leak, and if the water tank is not satisfied, the switch will not reach the water. It is also possible that the plug of the plugging tank is broken, or the connection with the button is loose, which will lead to the phenomenon of no water.
If the length of the pressure rod is not enough, it can not fully contact the internal pressure plate of the toilet, and the water cannot be opened, so after the key inspection, if it cannot be adjusted, it needs to be replaced with a new installation.
There may be three conditions that cause no water:
1. The water level of the water tank is high enough, and the flushing is not smooth, which is caused by air pressure. Check that the 2 side screw holes at the bottom of the toilet bowl are sealed. There must be some seams. >>>More
First, the toilet button is empty.
1.The toilet button is broken, and when you press it, it will be empty. It is necessary to replace the toilet button. Before replacing the button, drain the water in the toilet tank, close the toilet bowl's water valve, and remove the water tank cover. >>>More