What should I do if my bidet toilet is blocked by the brush head of a plastic toilet brush? Urgent!

1. Disconnect the water connection;

2. Cut the waterproof glue between the toilet bowl and the ground, and loosen it if there are screws;

3. Move the toilet bowl and remove the debris from the bottom with your hands.

4. Restore according to the reverse process.

If you are sure that it is a brush, you can usually take it out by hand from the front!

The above process is very simple, the toilet is sitting at the mouth of the ground sewer pipe, basically not fixed with screws, the waterproof glue is mainly to seal the odor to enhance and stabilize, it doesn't matter if you don't use it.

If you can't do it yourself, the cost of hiring someone shouldn't be too high!

FYI!

Brush heads? If it doesn't work, use a large cylinder at the mouth of the toilet drain hole, similar to a large water pipe, fill it with water, increase the water pressure of the toilet again, and flush away the brush head.

The brush head of the plastic toilet brush will not be blocked, and the water will slowly flow down.

If it's too convenient. Even the paper is blocked.

Ask the child's hand to touch it in. Is it still on the trap?

If not. It had gone down to the exit of the toilet.

You have to take it apart to take it out.

The 110 water pipe will not be blocked. Because the toilet outlet is small.

Hurry up and pull it out. If you don't block it, you have to dismantle the water pipe. It's troublesome.

Remove the bucket, it's more troublesome if it gets stuck in the sewer.

It is not very complicated to dismantle the bucket, you can go to the property for help.