What should I do if the flushing pressure is not enough after the toilet is blocked?

The pressure is not normal enough, it is enough to pass the pressure.

There is no thorough pass.

Under normal circumstances, any flush toilet, 4-5 years of use will be fouled, the original smooth ceramic surface of the fouling, it seriously affects the drainage capacity of the toilet, resulting in the inability to flush in time, slow drainage, which is usually caused in the process of use, generally the only longer way to appear this phenomenon is to replace the toilet, even if it is descaled in various ways, the siphon elbow inside the toilet can not be completely removed, there is a temporary improvement, and this phenomenon will still appear after a while.

First of all, it is forbidden to urinate in the toilet, even if it is necessary or unavoidable, it must be flushed out of the urine in time, do not be afraid of water, and secondly, you should not throw the paper into it after unraveling it; In addition, there is a subsection on the installation, that is, the toilet outlet must be left with a certain amount of water, if after flushing, the toilet outlet is always only a little bit of water left and even the outlet has not overflowed, so that when used, it will be directly stained with fecal dirt on the surface of the limb deficiency ceramic, which is extremely unhygienic and troublesome.

As long as you pay attention to the following points, it can be used for more than 10 years or more, except for general wearing parts.

Urinate frequently. Don't throw away paper sheets.

Wash frequently, but do not use sulfate hydrochloric acid, which will directly lead to damage to the ceramic surface.