-
Anonymous users2024-01-24I think your question is that the difference in the height of the floor tiles in the two areas is caused by the lack of connection, right? If that's the case, the best thing to do is to make a partition out of marble, you know what I mean? It is to leave a gap between the floor tiles in the two areas (the width depends on the situation, and it is good to be visually coordinated).
Fit a marble strip in this crevice. Its height is slightly higher than that of the tiles on both sides.
-
Anonymous users2024-01-23Didn't your master say that? How can this be, now I have to lay a cement pad a little higher, there is no way.
-
Anonymous users2024-01-22Two ways: first, spend more money to buy cement river sand, and make the living room floor as flat as the bathroom floor (this method is not recommended, because the dining room and living room are not flat) Second, continue to stick the living room, as flat as the dining room, but at the door of the bathroom to pad a very high threshold stone (stone), the threshold stone should be higher than the bathroom floor, in order to prevent the water from the bathroom from flowing into the living room. (Although this is not beautiful from the living room, it is the most cost-effective and helpless way).
-
Anonymous users2024-01-21You can ask a professional master to come to your door to have a look.
This kind of floor drain is a large water seal odor-proof floor drain, the water seal height reaches the national requirements of 5cm, and the water seal storage capacity exceeds 300ml, which can ensure that it does not dry up for 30 days, and there is no one at home for a long time in time, and there is no need to worry about the overflow of odorous germs, and the water seal of other products on the market is located in the drainage pipe, the volume is too small, and it is easy to dry up, resulting in the failure of the water seal, and it cannot play the role of actual anti-odor, anti-virus and anti-bacterial insects. At the same time, it also has a siphon function, and the water is faster than the general floor drain.
If you don't do a closed water test after doing waterproofing, then you can do a closed water test after pasting tiles. However, it is necessary to wait until the tile grout is completely dry, and to extend the closed water time appropriately, because the tile itself has a certain water barrier, so the extended time can make the results of the closed water test more accurate. >>>More
How long has it been since your bathroom was waterproofed? Is there a 48-72 hour closed water test after waterproofing? In general, there are two reasons for water leakage in the bathroom, one is that the pipe in the bathroom wall is broken, resulting in water leakage; The other is that there is a problem with the original waterproof layer of the bathroom, which leads to water leakage. >>>More
Generally, after 24 hours after pasting the floor tiles, it is necessary to use a special beauty joint agent to hook the joint, the role of the beauty joint agent is moisture-proof and water-resistant, and the tile is not easy to crack and beautiful and water-resistant. >>>More
If you don't want to change too much, it is recommended that the threshold stone at the door be slightly higher than the bathroom, so that after the laying is completed, you basically can't see that the tile of the bathroom is higher than the living room, and it also plays a role in blocking water. If the bricks of the bathroom are really not paved well, it is recommended to remove all the tiles of the bathroom and re-pave, after all, the tiles of the bathroom are relatively few, easy to change, and the amount of work is not large.