-
Anonymous users2024-01-24Step 1: Warm up the room as soon as possible. Before the moisture returns, heat the room with an electric stove or gas stove to reduce the temperature difference between indoor and outdoor. You can put hygroscopic substances such as quicklime (lumpy lime) in the room.
Step 2: Close doors and windows to reduce the influx of moisture into the room. When moisture regain occurs, the indoor air can be filtered with a dehumidifier"Dehydration"and continue to heat the room.
Step 3: The degree of moisture return is also different in different places indoors. If there is a build-up of hot air near the top of the ceiling, it is relatively dry, and the favorable microclimate environment in the corner of the ceiling can be used to store the items that are most afraid of moisture and mildew.
The walls around it were the coldest, and the ground in the north house was also cold, and the resurgence was the worst.
-
Anonymous users2024-01-23Use a blender to stir the plugging king into a paste, and then scrape it on the bathroom floor.
If you don't do it, you will regret it, and if something goes wrong in the future, you have to reorganize it, don't spend a lot of money to save a small amount of money. My home has just been renovated, and it should be waterproofed or can't be saved.
1. First of all, the foundation should be laid, and the wall must be waterproofed, and the wall should be waterproofed before the wall tiles are laid. In the general waterproof treatment, the wall should be waterproofed with a height of 30 cm, but for the non-load-bearing light wall, the entire wall should be waterproofed, at least 60 cm high. If you need to replace the original floor tiles in the bathroom, after chiseling off the original floor tiles, you must first level the ground with cement mortar, and then do waterproof treatment, so as to avoid leakage caused by uneven thickness of waterproof coating. >>>More
It is best not to tile before the waterproof is dry; It is mainly worried that the cement behind the tile will stick the waterproof layer to the point of destruction; >>>More
1. Bathroom waterproof construction steps.
Step 1: You can use a slightly coarser cement to base the foundation first, and then brush the waterproof paint after the cement is dry. But in painting money, the ground should be flat and there should be no grooves. Water is then sprinkled on the ground to expel the gas from the small holes. >>>More
It is condensate, and the air entering from the window comes into contact with the wall or floor, and the temperature changes rapidly, and the condensate is formed by pouring water. Specifically, you can know that I have a private message, and it is best to send a photo