-
Anonymous users2024-01-24Now that you know that the pressure is not enough, you need to test the pressure of the water pipe; Check if it's due to insufficient pressure in the tap water; If the pressure of the water pipe is insufficient, it is necessary to give feedback to the property or install an additional booster pump after the water meter to enhance the pressure of the indoor water intake;
If the faucet and the water pipe entering the tank are blocked due to long-term use, the hose needs to be replaced;
If it is caused by the blockage of the water inlet inside the water tank, it only needs to be cleaned to achieve the effect of increasing the water pressure;
Remarks: Insufficient water pressure will inevitably lead to problems such as slow water inflow into the water tank, or water incoming in. Then it is necessary to find out what causes the water pressure to be insufficient, and adjust or transform it to achieve the effect of water pressure enhancement;
Due to the improvement of living conditions, individual owners have installed water purification equipment such as "pre-filter" after entering the water meter, and some water pressure is not enough because the "pre-filter" has been used for a long time to cause sediment blockage, thereby reducing the water pressure, so it is necessary to replace the pre-filter.
Adding the water tank to a sufficient height or adding a tube rice booster pump between the water tank and the toilet bowl can do the trick. >>>More
The fittings in the water tank can be adjusted, the water outlet lever can control how much water should enter the water tank, and the flush valve can control the amount of flushing. So you can try it out. Put water in more points or water flush more points.
The toilet is not able to pump water, which is a problem that every family encounters. So what is the reason for it? And how do we solve it? >>>More
The toilet flush is not enough, and the toilet is not flushed clean, which may be a problem with the toilet shifter, that is, the water outlet of the toilet is not directly facing the sewer pipe, and there is a curve in the middle, which is connected when the toilet is installed. It is also possible that the toilet is blocked, after the toilet is blocked, when flushing, the water level will slowly rise, and the toilet will not be flushed. It is also possible that when you use it, you don't have a good reason to do it, and you don't let go when you press the flush button, which will also cause the impulse to be insufficient, and you must press it for 2-3 seconds, so that you can completely open the flush valve, and the flushing effect can be the best.
ear, the bridge will be op