-
Anonymous users2024-01-24The glass of the lamp is not movable, push it open. Or pry the ceiling panel next to it with something like a taper and it will be removed.
-
Anonymous users2024-01-23Integrated ceiling, this is generally sent with a suction cup, and the aluminum gusset next to it is sucked off with a suction cup for loading and unloading.
-
Anonymous users2024-01-22Remove a gusset first, and then cut off the lampshade by hand. It is better to have suction cups. It's so simple. It was all buttoned up piece by piece.
-
Anonymous users2024-01-21It's good to suck with a suction cup, the kind of suction cup you hang on the glass.
-
Anonymous users2024-01-20Round ceiling hanging.
Copy and dismantle of the lamp:
If the ceiling lamp in the living room is circular, you should pay attention to it when dismantling the DU, the first step: turn off the power of the ceiling lamp, only DAO will turn off the power supply, in order to ensure that the disassembly process is safe; Step 2: Use a screwdriver to slowly remove the 3 small screws around the iron ring of the lampshade, and then rotate the lampshade until it is unscrewed; Step 3:
Remove the bulb. Disassembly of recessed ceiling lamps:
The disassembly of this kind of ceiling lamp often scares a lot of people, they feel that it is very complicated, and it can't be removed at all, in fact, if you think about it carefully, since it can not fall off on it, there must be something to get it stuck, so if you are careful, you can find that there is a spring clip to jam it, as long as it is broken off, remember, you must cut off the power before taking it.
Disassembly of aluminum gusset ceiling lamp:
Dismantling of rectangular ceiling chandeliers:
Rectangular ceiling lamps are more cumbersome to remove than round ceiling lamps. Of course, the basic steps are still similar, the first step: cut off the power supply; Step 2:
Take the lampshade, the lampshade of the rectangular ceiling lamp should start from his four corners, use the washing hook of the suction glass disc, suck the aluminum alloy part on the side, and slowly pull down (note: each corner should be pulled), until the lampshade is removed; Step 3: Remove the bulb.
Flashy, colored LEDs are useless.
Because the main light source must have lights, it is enough to use the light strip as a decorative light source, and it is economical. For the lamp, T5 is generally used, which is too bright, even if it is a warm light source.
First cut off the power supply, use the suction cup (the kind of hook on the tile, made of rubber) to suck the electrical panel, and take the electrical panel off (the suction position should be cautious and the action should be light). Then pull the lamp buckle away, unplug the lamp, replace the lamp, buckle the button, and cover the panel. Replace the lamp with the original ballast. >>>More
It was the iron chassis that had moisture and rust. Knock on the bottom edge of the iron with the handle of the screwdriver and try again. It is necessary to replace the shunt switch in the lamp, which should not be easy to repair, and the small plastic shell.
The panel of the lamp is also a gusset, insert it into the gap between the board and the board with a wallpaper knife, pry it lightly, it will pry out the panel a little, and then continue to pry, pay attention to the tentative, do it carefully, so as not to scratch the paint on the surface with the knife. Break it off with your hands. >>>More