-
It was the iron chassis that had moisture and rust. Knock on the bottom edge of the iron with the handle of the screwdriver and try again. It is necessary to replace the shunt switch in the lamp, which should not be easy to repair, and the small plastic shell.
-
The bathroom round lampshade is generally clothed with 3 locks on the circumference of the horizontal plane, which needs to be screwed out horizontally.
-
It's broken down, hold down one side and the other side hard break, and it's down, there should be 3 wire springs pinned inside, light up and want to be able to see the point, you mix it and try it.
-
Pull it with both hands.
The lampshade will come down a little.
I saw that there was a wire-like thing stuck in the lampshade.
Flip it open and you can remove the lampshade.
-
There are 3 evenly distributed locks on the round lampshade in the bathroom, which are screwed outward, and that's it.
The light in the living room is 4 locks.
-
The one in your bathroom is a ceiling lamp, the cover is a rotary knob, and if the living room is all off, it is likely that the section switch is broken, and if you have a problem, you can contact me immediately I am a light.
-
The lampshade of the bathroom should be rotated counterclockwise, and the reason for not moving is that it is stuck, and it is necessary to use force. The lights in the living room are not very clear.
-
One may be a broken light bulb.
The decorative cover of the outer layer is snapped in. As long as you open the outer decorative cover, you can see the fixing screws inside, and you can remove the screws by removing them. The cover is also at the same time. >>>More
On both sides is a spring card, you can cancel it by deducting it down, if you just change the lamp tube, you can see the place where there is PRESS on the lampshade, press the transparent lampshade outside and it opens, I open the lamp shop, you can ask me if you have any questions.
Removal Steps:
1. Turn off the light switch and turn off the main switch of the road. >>>More
This kind of lampshade is generally hung up, the white part is slightly upturned and rotated, that side can be loosened on that side, and there are also some buckles, similar to the kind on the blinds, touch it to see where it is, you can take the lampshade off with a pull, you try to see,
You're installing a plastic gusset and the lights are anti-foggy. >>>More