How to avoid mold and water seepage on the walls and floors of the bathroom?

The toilet should be in a place where sunlight can shine, and the air humidity in the bathroom should be kept clean and tidy.

When decorating the floor tiles, these should be handled well, sealed, and the bathroom should be in a place where the sun can shine.

You can choose some waterproof floor tiles when decorating.

Personally, it is recommended to keep the air humidity and clean in the bathroom.

When decorating, use a good waterproof coating for waterproofing to prevent ground water penetration.

First of all, when decorating, you should buy good quality forced flooring and other materials, and in addition, you should clean it for a long time, and don't always let it soak in water.

I think we can redecorate the walls and floors, or stick them tightly.

My personal advice is to use a good waterproof material for the renovation.

I think my personal recommendation is to keep the humidity in the bathroom as much as possible.

We can do it from the material, but also from the partition wall of the wall! Let's find out more about it!

It needs to be waterproof and standard.

Did the guest room bathroom be renovated by yourself, or did the location of the door change? The standard practice is that there is no bathroom waterproof beam except for the bottom of the bathroom door, and there are waterproof beams at the bottom of other walls; Therefore, if you remodel the walls yourself,You need to project a 15 cm waterproof beam at the bottom. Because the density of cast-in-place beams is significantly higher than that of direct brick masonry walls, the waterproofing performance is better;

Moreover, the walls are all made of waterproof coatings, and the ground and walls need to be done, and the waterproof paint is dried twice; The closed water test can be performed for another 48 hours.

If the walls are remodeled, it must be remembered that in order to save space, the partition wall between the room and the bathroom should not be made too thin. At least 12 cm partition walls should be made to ensure waterproofness.

The restrooms are usually waterproofed, the floor is made of polypropylene twice, and the tap water in the restroom is at the 110 drop pipe (squatting position). When attaching floor tiles, the plasterer is required to nail 1-2 small holes at the lowest point of more than 110 pipes and waterproof, and then install a squatting position. With such treatment, even if water seeps out of the wall or floor, it will flow out of the small hole.

It's not much use for you to redo the shower area now. You can't find the lowest point of the toilet.

The above are some measures to prevent mold on our walls, I hope it will help you!