The bathroom is more than just a place to go to the toilet, how can you have a comfortable bathroom?

You can isolate the toilet area from the shower area, and the toilet area should be cleaned frequently.

The bathroom should be washed to keep it clean and comfortable in a comfortable environment

You can separate wet and dry and clean it frequently, and you can have a brand new bathroom.

Separate the toilet from the shower to keep the toilet clean and hygienic.

There is also a place to take a bath in the bathroom, and if you can't separate them, you can clean them frequently without peculiar smell.

Do a good job of odor treatment, ventilate more, choose plain colors, and clean more.

Pay attention to the environment of the toilet every day and keep the toilet clean and hygienic.

It depends on how the owner of the house cleans up his bathroom.

To have a comfortable bathroom, you need to be diligent every day.

First we want toAvoid overly damp houses! Keep dry and some wall treatments!

1. Brush waterproof paint for the first time.

Before construction, make sure the construction site is clean and dry. The waterproof coating is fully applied, no omissions, firmly integrated with the base layer, and free of cracks, bubbles and peeling. The coating height is consistent and the thickness meets the requirements of the product specification.

PS: Floor drains, corners, pipe heels and other joints should be coated with high-elastic and flexible waterproof coatings, because the joints between the bathroom wall and the floor will be displaced, and water seepage is the most susceptible.

Brush with a second layer of waterproof paint. Please note that there should be a certain time interval between the two waterproofing coatings, and the second should only be done after the coating has dried completely. The exact time depends on the coating.

If the interval is too short, the waterproofing effect will be greatly reduced.

3.Laying a protective layer. In order to prevent subsequent construction from damaging the waterproofing layer, it is necessary to lay a protective layer on the surface of the waterproofing coating. The protective layer should be completely covered with the waterproof layer without omission and firmly bonded to the base layer without cracks, bubbles and peeling.

4.Closed water test. During the closed water test, the waterline at the grounding point should not be less than 2 cm, after no leakage is observedIt should be maintained for at least 24 hours to be considered eligible. If there is a leak, it needs to be redone and cannot be ignored.