-
Anonymous users2024-01-24LED lamps cannot be used with electronic switches, remote control devices and switches with LED indicators, because the LED lamps will flash or light up in the state of microcurrent, and the above devices actually have microcurrent in the circuit. Connecting the live wire alone and then touching the lamp body with your hand actually forms a circuit with the human body, and there is a slight brightness under this weak current.
-
Anonymous users2024-01-23There is a slight problem with the switch tube and it is recommended to replace it.
Induce electricity, the current is weak, and the meter is not run. The landlord replaced the two wires under the switch of the lighting switch of the distribution box at home to ensure that it is no longer bright, remember to give my family points. Pay attention to safety when adjusting the cable, and pull down the switches to ensure safety.
Because the remote control is turned off on the inside of the lamp body, the remote control uses the principle of electronics to turn off the power, and there is a little current to impact the light source. The switch is to turn off the power completely, so it is best to turn off the switch when you sleep at night.
The types of remote control switches are different, and it is convenient to have a control with power on, but it is not good where the mains power is often cut off (the lights are inexplicably turned on in the middle of the night).
This is because your switch is not connected to the live wire, the LED trigger current is very small, and the induced electricity can make it slightly bright, and the tungsten lamp that is not LED lights up is hundreds of times larger than the LED, of course, it will not be lit, and the fluorescent lamp sometimes has an induced voltage that will be slightly bright at one end, which is caused by the switch not passing the live wire. ，
To use a two-color light source, with a stepless dimming driver, and then this driver will have a matching remote control, after installation, the code, that is, you can adjust the brightness and color temperature at will. >>>More