When the old lights in the living room are replaced with LED lights, can the three control switch st

Abnormal, the biggest possibility is that there is a problem with the drive, it may be a leakage, that is, there is a conductive part connected to the ground wire, because we are using alternating current, although the switch is turned off, but only one pole (live wire or neutral wire) is turned off, and the current will still be generated, but the leakage is not directly conducted on the ground wire but through a larger resistance, so the current is smaller, and only in a dark environment can you see that there is light.

Generally, there are 6 chandeliers for household use. There are 9 more. If you're going to control it in groups. >>>More

Replace the stepless drive and stepless remote control, and the wiring will be normal. Pair codes.

Egg pain, 5 wires should be 1 live wire 2 control line 2 zero line, see if there is a color distinction, the green is the zero line, two direct docking, not through the switch, the remaining 4 holes, you should first use an electric pen to find that live wire, and then divide it into two lines, this is not 4 wires, find the position hole of the live wire on the switch, it should be marked with letters, is N or L forgot, try it this way, at most it is tripping hehe.

After the living room lights are double-controlled, after the lights are turned off, why the LED lights will keep flashing, there may be the following two kinds of LED lights that have been flashing: the first is that the line is in poor contact, and the switch or connector will flash if it is loose; The second is that the power supply of the LED lamp is insufficient, which requires repair or replacement of the LED driver. Most of them are caused by poor drives, but of course, there are also cases where mice bite the wiring half-off. >>>More