-
Anonymous users2024-01-24This is because your switch is not connected to the live wire, the LED trigger current is very small, and the induced electricity can make it slightly bright, and the tungsten lamp that is not LED lights up is hundreds of times larger than the LED, of course, it will not be lit, and the fluorescent lamp sometimes has an induced voltage that will be slightly bright at one end, which is caused by the switch not passing the live wire. ，
Induce electricity, the current is weak, and the meter is not run. The landlord replaced the two wires under the switch of the lighting switch of the distribution box at home to ensure that it is no longer bright, remember to give my family points. Pay attention to safety when adjusting the cable, and pull down the switches to ensure safety.
It shouldn't be, it's the wrong installation, the ground wire is used as a neutral line, or the light line is not connected correctly. Even if the wire is discharged through the pipe, the voltage will not be reduced.
This situation is a bit dangerous, so don't touch it and find a professional! There is that kind of touch switch waterproof, not easy to burn up, wet hands can touch, buy a switch in the future try to use this kind of one, my family just bought, it seems to be called seven forces touch switch.
This is because the power of the bath bomb is relatively large, and the contact is burned out due to the bad heating inside the switch, and the light will not heat up anymore, so there is no risk of fire, but the switch needs to be replaced.
If you can unscrew it, re-tighten it a little and see if the toilet light is broken