What is the reason for the upward seepage of water through the tile gap next to the toilet in my bat

Updated on Bathroom 2024-08-13
4 answers
  1. Anonymous users2024-01-24

    If the flush has water back up, there is a gap in the interface or the drainage pipe is damaged, and the water comes up again outside the pipe, more information, better advice, free concrete waterproofing and leakage water repair technical advice, to avoid the trouble of repairing today, leaking tomorrow, repairing every year, and leaking every year.

  2. Anonymous users2024-01-23

    There may be a leak in the water pipes under the tiles! It's best to find a professional worker to test the waters! The national standard is 8MPa, and generally they only play 6MPa.

  3. Anonymous users2024-01-22

    1.There is a leak at the toilet connection2, and there is a leak in the pipe under the floor tiles on the waterproof layer.

  4. Anonymous users2024-01-21

    It's that the float in the tank is not good, and if the water can't be completely sealed after the water is finished, it will leak out.

Related questions
7 answers2024-08-13

There are several reasons like this, 1--- when you lay the tiles, it should be higher than the sewage outlet, so there is a gap between the sewage outlet and the tile, and it is empty, which causes the toilet to drain, along the gap between the sewage outlet and the tile, to flow out, the solution is to remove the toilet and fill it with a leak plugging spirit [a kind of waterproof material, quick drying] and smooth it. Cement can also be waited for 24 hours, which is not too advisable. 2--- is that the toilet itself and the ground sewage outlet are not well sealed, the solution, remove the toilet, buy 2 catties or 3 catties of putty and buy a sealing ring, and reinstall it. >>>More

1 answers2024-08-13

It's not good, maybe it's bad caulk. If the surface can see that the underside of the tile has become darker, it means that the tile body is too loose and absorbs water and changes color.

9 answers2024-08-13

That's a good idea. And it's also relatively easy to implement. The specific method is to fill the caulk first, and then raise the gap to a depth of 2 3 mm, so that even if the caulk solidifies, it will not affect you to make a beautiful sewing agent.

4 answers2024-08-13

Hello, you are saturated with water on the floor of the bathroom, because the water of your shower only flows into the floor drain on the surface of the brick, and the water seeping under the brick has no place to flow, the reason is that the floor drain pipe is too high and not flat with the ground during the decoration, so the water can not seep into the floor drain. Over time, the water under the bathroom floor will have a peculiar smell and small flying insects. The reason why you can deduct this beautiful seam is because the ground is wet, and the ground must be completely dried before doing beautiful seams. >>>More

3 answers2024-08-13

In the event of crevice water seepage, check whether there are pressurized pipelines passing through the leakage point and equip parts (pipe hoops, joints, etc.). Then treat it symptomatically.