-
In the event of crevice water seepage, check whether there are pressurized pipelines passing through the leakage point and equip parts (pipe hoops, joints, etc.). Then treat it symptomatically.
-
Let me tell you: there is leakage in the bathroom floor, the reason is that the waterproof layer is not done well, and the connection of the toilet flush is poorly sealed or the tap water connector leaks more!
-
Are your water pipes concealed?
After the bathroom floor is waterproofed, the tiles are seamed with Sika or other brands of grout, and there is no need to do waterproofing.
Use a dry cloth to rub the dry powder caulk into the tile joint, because the tile joint is wet, and the dry powder will stick after entering.
When caulking, pay attention: the previous gap must be cleaned with a blade, and there should be no impurities. The water on the ground should be wiped clean as much as possible, and the caulk should be mixed with water, not too dry or too thin, and the maximum viscosity should be advisable. >>>More
Hello, you are saturated with water on the floor of the bathroom, because the water of your shower only flows into the floor drain on the surface of the brick, and the water seeping under the brick has no place to flow, the reason is that the floor drain pipe is too high and not flat with the ground during the decoration, so the water can not seep into the floor drain. Over time, the water under the bathroom floor will have a peculiar smell and small flying insects. The reason why you can deduct this beautiful seam is because the ground is wet, and the ground must be completely dried before doing beautiful seams. >>>More
Then you have to redo the waterproofing to completely solve it. Bathroom waterproofing must be done well, once the leakage will cause tension in the neighborhood, and if it is not handled well, it will cause trouble in lawsuits. >>>More