How to waterproof the bathroom and what should I pay attention to?

Updated on Bathroom 2024-08-20
2 answers
  1. Anonymous users2024-01-24

    Regarding the waterproofing of the bathroom, I can give you the following suggestions::

    1.The first thing to pay attention to when doing waterproofing in the bathroom is the choice of waterproof materials, and it is recommended that you can directly use the waterproof slurry in the kitchen and bathroom, which is specially developed for the yin and yang angles that are easy to seep into the kitchen and bathroom, wear pipes, sanitary ware, floor drain peripherals, etc., so the special materials are dedicated, the pertinence is stronger, and the waterproof effect is of course better.

    2.The construction of waterproofing should be carried out in accordance with the requirements of the manual, the proportion of waterproof materials, the standard thickness and height of construction, etc., so as to ensure a good waterproof effect.

    3.After doing a good job of waterproofing, it is necessary to do a good job of sprinkling and maintenance in the later stage, and places with direct sunlight need to be covered and covered.

    4.The base surface before waterproofing must be cleaned, there can be no oil and dust, etc., and it must be sprinkled with water to moisten, but there must be no stagnant water.

    5.After the waterproofing is completed, remember to do a 48-72 hour closed water test to check whether there are any leaks in the waterproof construction and whether the waterproof function is normal.

  2. Anonymous users2024-01-23

    The waterproofing of the bathroom needs to pay attention to the following points:

    1. The waterproof material must be of good quality and cannot be bought;

    2. The ground must be brushed fine for waterproofing, and no dead corners can be left;

    3. Pay special attention to the 30cm waterproof layer on the wall and the corner of the wall should be even, and no cracks can occur;

    4. The waterproof material needs to be done 3 times, with an interval of 2 days between each time, to ensure that it is dry thoroughly;

    After the completion of the test, do a water storage experiment, the test time is 2 days, and it is necessary to block the door of the bathroom with sand to ensure that the water does not flow out;

    If there is no leakage in the walls of the downstairs and adjacent bathrooms within a few days, the waterproofing will be successful, and the property will be accepted.

    At this point, the waterproofing is complete. Hope it helps!

Related questions
3 answers2024-08-20

1. The bathroom floor is leveled first. If you're replacing the floor tiles in the bathroom, be sure to level the floor with cement mortar before waterproofing it after chiseling off the original tiles. This avoids leakage of the waterproofing coating due to uneven thickness. >>>More

1 answers2024-08-20

1. Bathroom waterproof construction steps.

Step 1: You can use slightly coarser cement as a primer first, and wait for the cement to dry before brushing the waterproof coating. But in painting money, the ground should be flat and there should be no grooves. Water is then sprinkled on the ground to expel the gas from the small holes. >>>More

4 answers2024-08-20

Wall treatment is also important. In the general toilet waterproofing treatment, the wall should also be made about 30 cm high waterproof paint to prevent water from penetrating the wall. However, if the wall of the bathroom is a non-load-bearing lightweight wall, the entire wall should be coated with waterproof paint. >>>More

1 answers2024-08-20

Do not overdo it with fertilizer;

Watering should be moderate; >>>More

2 answers2024-08-20

Regarding the waterproofing of the bathroom, I can give you the following suggestions:: >>>More