-
Anonymous users2024-01-24The bathroom with prefabricated panels is no different from cast-in-place when it is waterproofed.
Bathroom waterproofing, can be treated from the following three aspects:
1.Waterproofing requirements.
Bathroom waterproofing, the standard approach is that the ground needs to be done all, the wall should be at least meters high, it is recommended to do full height, if it is a wallpaper wall, then it must be done full height;
2.Waterproof material.
The most susceptible water seepage in the bathroom is the yin and yang corners, pipes, sanitary ware, floor drains and other places, so the most waterproof time to use kitchen and bathroom waterproof slurry, first key parts to repair and strengthen, and then the overall waterproofing, so that you can meet the requirements of waterproofing.
3.standard construction.
In addition to the height of the waterproof, the thickness of the waterproof brush, the time between each coating, and the later maintenance after the waterproof material are also very important.
The first step is to remind everyone that the water circuit of the bathroom should be observed and transformed in combination with the actual situation, so as to have a detailed understanding of the concealment project. After the plan is determined, the water, electricity and heating pipes are laid and chiseled. Secondly, in the base treatment, the original decorative materials should be cleaned before the waterproofing project of the bathroom, and then the several sides are paved with cement slurry, and then the waterproof treatment is carried out. >>>More
1. Bathroom waterproof construction steps.
Step 1: You can use a slightly coarser cement to base the foundation first, and then brush the waterproof paint after the cement is dry. But in painting money, the ground should be flat and there should be no grooves. Water is then sprinkled on the ground to expel the gas from the small holes. >>>More
How to waterproof the ceiling.
1. The base layer of the construction area generally has surface floating dust and loose concrete, so the surface should be treated with a polishing machine to clean and remove the surface water and oil traces. >>>More
The simpler way to do this is to remove the tiles, make a layer of waterproof paste, and then re-apply the tiles with tile adhesive.
1. Polyurethane waterproofing (is extracted from asphalt). Please don't buy coal coke refined, it's too toxic. >>>More