After the toilet is flushed, the toilet holds too much water, what is the matter?

It is caused by excessive water output each time, and can be adjusted in the following ways.

1. The first choice is to open the toilet lid, and handle it gently to prevent the lid from being broken.

2. After the toilet lid is removed, you can see that there are two black columns on the toilet lid, which is the toilet water discharge connecting rod, which can be adjusted in length to control the strength of the toilet button.

4. Adjust the position of the float on the left side, and rotate the white rod in the circle, which can be used to adjust the height of the float, and adjust it to the position shown in the figure.

5. In front of the water release button, there is also a yellow block that can be moved up and down to adjust the toilet drainage, and if you move it up to reduce the drainage, you won't store too much water.

How to adjust the toilet puddle with too much water? The detailed method will be taught to you, so let's learn it quickly.

It has nothing to do with the long horizontal length of the sewer pipe or the lack of slope, open the lid of the water tank, you can see that the water cleaner has a small hose on it (this is the water supply pipe), whether this small root is inserted in the overflow hole of the double-press sanitary ware (a relatively high vertical pipe in the water tank), take out this small pipe from the overflow hole and directly into the water tank can reduce the water storage in the toilet. Raising the front of the toilet bowl appropriately when filling the toilet can also reduce water storage.

It is caused by the fact that the water output is too much in the belt each time, and it can be adjusted in the following ways.

1. The first choice is to open the toilet lid, and handle it gently to prevent the lid from being broken.

>2. After the toilet lid is removed, you can see that there are two black columns on the toilet lid, which is the toilet water discharge connecting rod, which can be adjusted to control the strength of the toilet button.

4. Adjust the position of the float on the left side, and rotate the white rod in the circle, which can be used to adjust the height of the float, and adjust it to the position shown in the figure.

5. In front of the water release button, there is also a yellow block that can be moved up and down to adjust the toilet drainage, and if you move it up to reduce the drainage, you won't store too much water.

After the toilet is flushed, the toilet holds too much water, what is the matter?

First, because the construction personnel have problems during the construction of the trap, when the outlet of the trap is higher than the basin, it will cause too much backwater, and it is best to find the construction personnel to repair the fixture or rehaul the installation. The second is because the design of the toilet bend is unreasonable, there are defects when leaving the kiln, or the sewer transformation is unreasonable. In addition, the water level of the water tank can be lowered by adjusting the inlet valve, or the switch of the full row adjustment of the drain valve can be adjusted to delay or delay the sealing time of the drain valve.