-
Anonymous users2024-01-24There is a water-stopping device in the toilet, an upside-down plastic box, when the water floods to the water-stopping device, the plastic box begins to float and drives the water-stop valve to start to stop the water, and when the plastic box rises to a certain height, the water-stop valve will be completely closed by the lifting force of the plastic box. So this is completely normal, and the lid on the top of the toilet bowl can be directly removed.
There is no water in the toilet after flushing: close the toilet lid and check whether the button can reach the inlet valve, if so, adjust the inlet valve to the lower position, and then see if the float or float of the inlet valve moves up and down freely. >>>More
Because there is a setting in the toilet, you can check that there is no water, and it will automatically be watered, and if there is water, it will not be watered, it will be detected intelligently, so it can be automatic.
Dirty, the main function of the trap is to prevent odor and backflow, and it is directly connected to the sewer, where the water must be very dirty and there are many bacteria.
The siphon toilet is designed according to the principle of the connector, if the water leaks it means that there is air leakage in the part, reduce the set water level height and siphon function of the connector, replace or re-play the glass glue as soon as possible to no leakage at all, pay attention to the glass glue within 24 hours after the glass glue is not watered, and wait for the glass glue to fully solidify before use.
All kinds of toilets are different, so the trap is large and small, and there are generally about two catties of water.