-
Anonymous users2024-01-24The water valve on the toilet bowl can be done in the following five steps.
Tools Required: Removing the toilet valve is simple and does not require tools.
1. Turn off the water pipe connected to the toilet first, and unscrew the place where the toilet water pipe is connected, the purpose of this step is to prevent the toilet from leaking.
2. After draining the water in the water tank, unscrew the leak plugging screw on the outside of the toilet valve.
3. Open the lid of the toilet tank, generally speaking, there are no screws and sealant on this cover, just take it away.
4. The blue one is the toilet valve, and the white suction pipe can be pulled out directly.
5. In this way, all the connection points of the toilet valve are removed, and the toilet valve can be taken out directly.
Notes: If the purpose of disassembling the toilet valve is to replace it with a new one, then the old screws and suction pipes can be left on because these can be used universally.
How to install and disassemble the toilet drain valve, life tips are given to you, and you can learn it after reading it.
3. Next, find the drain valve in the toilet tank and observe the composition and structure of the toilet drain valve, as shown in the figure below. >>>More
Directly open the gray plastic piece and remove the orange horizontal bracket to remove the component.
Don't dismantle this, give you the most feasible solution: use the saw blade to cut the white pipe from the top of the pink, the white pipe is hollow plastic, if the position is not too lame, it will be sawed off in 2 minutes, and your hose has to be changed, the nuts are rusty.
There are several kinds of <> drain valves, and the picture is for reference. If there is water in the water tank and cannot be pressed, it is a drain valve problem; If the water inlet is normal, the water tank cannot hold water, which is also a drain valve problem; If you can't get water, it may be a problem with the water inlet valve. FYI. (Image quoted from image).