-
Anonymous users2024-01-24The toilet may be stuck on the flush switch of the toilet, so you can press the switch a few more times; It could also be that the water level of the tank is too high, or the outlet of the tank is blocked, which can cause the toilet to be flooded all the time.
Reasons and solutions for the toilet bowl to be drained all the time:
1. First of all, you can check whether the flush switch is restored to its original state, because the flush switch in some toilets is easy to wear out after being used for a long time, or it is stuck, so it cannot be restored. Typically, the switch can be reset by repeating it a few times.
2. You can check the limiting device of the water level of the lower tank, whether there is a loose phenomenon, or whether it is too high, if it is too high, it will cause the water in the water tank to exceed the overflow water level and flow into the toilet from the overflow pipe, if the water level of the water tank is too high, it is necessary to find maintenance personnel to repair it in time.
3. You can also check whether the outlet of the lower tank is blocked. If the plug at its outlet is worn or something is blocked because of it, the plug is not tightly sealed, and the toilet will also run out. If this is the reason, replace the plug in time or clean it in time.
-
Anonymous users2024-01-231.You only need to close the water inlet valve, open the upper cover of the water tank, remove the blue plastic soft cover on the water feeder (the round pipe and other devices), then remove the small bolt at the other end of the float, remove the small round black rubber gasket, turn it over and install it again, and finally install the parts as they are, which will generally solve the problem;
2.The toilet inlet device can not be closed normally, it may also be that the float valve of the water tank is damaged, because it does not have the automatic floating closing effect, the water inlet does not stop working, and it is always in a state of non-stop watering, you can open the toilet lid, observe the flexible state of the float and other accessories, whether there is any accessory friction obstruction interference, it is still not possible to rule out these possibilities, it is recommended to replace the new float valve device.
Toilet: Officially known as a toilet, a toilet is a bucket with a lid for urination and defecation. The history of the toilet can be traced back to the Han Dynasty, when the toilet was called Huzi, which was dedicated to the emperor, and legend has it that it was made of jade.
It was held by eunuchs who served the emperor at any time. Later, in the Tang Dynasty, because there was a person named Li Hu in the emperor's family, in order to avoid secrecy, he changed the name of Huzi to Beast or Mazi. After that, in the circulation, it evolved into the name of the toilet.
With the development of science and technology, there are many novel varieties, such as the use of siphon, spiral siphon and jet siphon, super-spin siphon and other principles of flush toilets.
Toilet maintenance: 1. Do not place in direct sunlight, near direct heat sources or exposed to oil smoke, otherwise it will cause discoloration.
2. Do not place hard objects and heavy objects, such as water tank covers, flower pots, buckets, pots, etc., otherwise it will scratch the surface or cause cracking.
3. The cover plate and seat ring should be cleaned with a soft cloth, and strong acid, strong carbon and decontamination powder should not be used to clean with volatilizers, thinners or other chemicals, otherwise the surface will be corroded. Do not use sharp objects such as wire brushes and blades for cleaning.
4. When the cover plate is installed in the no water tank and low water tank, people should not lean back, otherwise it will cause breaking.
5. The cover plate should be opened and closed lightly to avoid direct collision with the water tank and leave marks and affect the appearance; may cause breakage.
6. Pay attention to the products using metal seat hinges (metal screws), and do not let acidic and alkaline solvents adhere to the products, otherwise it is easy to rust.
-
Anonymous users2024-01-22If there is a problem with the sewer pipe, check whether the sewer connection is loose or damaged. If the water pipe is rotten, it can be replaced with a new one. The waterway connection is loose, and the interface position is fixed with materials such as iron wire.
-
Anonymous users2024-01-21What should I do if the toilet tank keeps running water?
-
Anonymous users2024-01-20What to do if the toilet tank keeps running water.
1.You only need to close the water inlet valve, open the upper cover of the water tank, remove the blue plastic soft cover on the water feeder (the round pipe and other devices), then remove the small bolt at the other end of the float, remove the small round black rubber gasket, turn it over and install it again, and finally install the parts as they are, which will generally solve the problem; >>>More
A method is described that you can try.
I don't know how to flush the toilet in your house, if the momentum is relatively large, you can do it, if you haven't prepared a large basin of water (you can use garbage without water.) >>>More
What should I do if my toilet keeps putting water in the tank? The master teaches you by hand, do it yourself, and don't need to spend money to fix it.
The principle should be like this, there is a water float in it, and when the water is full, it will reach the ball, and the ball will be connected to a piston, and the water dragon mouth will be plugged. When flushed, the piston opens and water comes in. It may be that the ball is broken, there is no way to control the water level, or other parts are broken, just let people come to see and repair it.
Maybe it's because the valve lever is stuck, I don't know if you pay attention to it, the general principle of the toilet tank is that there is a float inside (most of them are hollow balls). >>>More