-
Anonymous users2024-01-24What should I do if the toilet tank keeps getting water and can't stop.
-
Anonymous users2024-01-23The toilet bowl has an air bag on the inside.
Once the airbag is pushed up to a certain position by the buoyancy of the water.
will stop flushing.
Your problem should be that the airbag is broken or the airbag stent is broken.
Turn the tank on and take a look.
If that's what I'm talking about, I'm going to change the airbag or the balloon holder.
-
Anonymous users2024-01-22Answer: If the toilet inlet equipment cannot be turned off, it is likely that the float valve is broken, resulting in the failure to close the function, and the water inlet does not stop working, and it has been in the water situation. At this time, you need to open the toilet lid to check whether the float and other accessories are sensitive, whether there is friction, etc. If these problems are not cleared, it is recommended to replace the ball valve unit with a new one.
If you have any questions, you can ask me.
If you're still satisfied, please give me a thumbs up!
-
Anonymous users2024-01-21There are two reasons for this:
1. The float is broken when the water tank is closed, which is generally less, mainly because the float bracket shaft is not flexible.
2. The aging of rubber water plug is not tight.
Solution: Generally, there is no need to replace it.
You first put the water out, open the tank, gently shake the float rod with your hands, and lift the float ball to reset the pole and observe whether there is water leakage, if it is the first reason, the problem can be solved.
If there is still a water leak, you should check the piston leather pad on the upper and lower moving parts at the other end of the float strut to remove the dirt on it and put it back in place, and the general problem can be solved.
It's easy to fix it yourself.
-
Anonymous users2024-01-20It's better to change the assembly, it's not expensive!
-
Anonymous users2024-01-19Change to an airbag or airbag holder.
You can change the inlet valve, go to the nearby store that sells toilets, water tank accessories stores or building materials stores to take a look and ask to buy one, the water inlet valve can be divided: float type inlet valve (about 10 yuan), lifting water inlet valve (about 15 yuan), the lifting water inlet valve is better, the water level of the water tank can be adjusted, and it will not affect the drainage valve. When removing the original inlet valve, remove the iron nut of a hose connected to the outside of the water tank with the plate head, and then remove the plastic nut at the bottom of the outside of the water tank (not at the bottom of the water), and the new inlet valve can be installed according to the original method, which is very convenient.
If there is a water leak, if you know it, you will open it to see where the problem is, and if you don't understand, you will find a maintenance master.
First of all, it is necessary to distinguish whether it is a problem with the inlet valve or a problem with the flush valve. Open the water tank cover, the water level is high, generally the water inlet valve problem; The low water level is a problem with the flush valve. FYI.
Maybe it's because the valve lever is stuck, I don't know if you pay attention to it, the general principle of the toilet tank is that there is a float inside (most of them are hollow balls). >>>More
If the toilet is always on the water, maybe it is a problem with the water tank, you can check whether the material or parts of the water tank will be too old, because some small parts are relatively unused, and it will not take long for the phenomenon of damage, if it is used for a long time, there will be problems, then it is a phenomenon of natural wear and tear, as long as it is replaced, the phenomenon of leakage on the toilet does not stop and cannot be eliminated, it may be because of the sewer pipe, because the function of the sewer pipe is used to connect the toilet tank, It is also possible for a major conveyor pipe to have this problem.