-
Anonymous users2024-01-24The reason why the toilet flush valve is not closed tightly is caused by the toilet flushing and can be repaired using the following methods.
Materials required: slotted taper, rubber sheet, double-sided tape.
1. Take off the toilet lid first, and you can see the drain valve group in the toilet.
2. After that, pull out the blue inlet valve group with your hand upward.
3. The buckle on the blue lid, press and hold the buckle to take off the blue lid.
4. There is a sealing ring in the middle of the bottom of the float, and injecting water into the sealing ring will bulge up, and finally close the water inlet valve.
5. Remove the rubber ring at the bottom of the sealing ring, paste the rubber sheet on it with double-sided tape, trim it and then install it back, so that it will not be replenished all the time.
-
Anonymous users2024-01-23Flush toilet refill pipe has been non-stop solution:
Learn how toilets are flushed. Different toilets may be different, but they work in much the same way. Open the lid of the flush sink and rinse it yourself twice to see how it works.
Inside the flush tank, from left to right: flush valve and float, water supply pipe, water stop pipe and flush ball. The handle is attached to the lever and the steel rope.
When pressing the handle, the steel rope lifts the flush ball, allowing the water in the trough to flow slowly into the toilet bowl through the hole at the bottom. When the water level gets low, the ball plug will fall and plug the hole at the bottom.
When the water flows out, the float sinks. The float is connected to the valve for discharging water, the float sinks, the drain valve opens, and the drain valve closes when the float rises.
There is also an overflow pipe in the middle to put water into the toilet sink when the water level is too high.
-
Anonymous users2024-01-22The toilet was full and flowed out.
-
Anonymous users2024-01-21Summary. Hello, if the toilet does not stop flooding because of the water tank, then you should check the material of the water tank in detail to see if there is aging, damage, etc., or check in detail whether the relevant accessories in the tank are aging, damaged, etc.
How to solve the problem of non-stop water replenishment after toilet flushing?
Hello, if the toilet does not stop flooding because of the water tank, then you should check the material of the water tank in detail to see if there is aging, damage, etc., or check in detail whether the relevant accessories in the tank are aging, damaged, etc.
Remove the lid of the toilet tank, and then check the various accessories inside the tank in detail to see which accessories are aging, damaged, etc., and then just replace the problematic parts with new ones.
What you touch in your hand is the float rod, but after a long time, you should change to a water inlet control valve, and if the drain valve is easy to use, you can continue to use it.
1. Flush switch problem.
You can check whether the flush switch is restored to its original state, because the flush switch in some toilets is easy to wear out after being used for a long time, or it is stuck, so it cannot be restored. Typically, the switch can be reset by repeating it a few times. >>>More
The water supply pipe is not fixed, if you want the water supply pipe to stay in the original position, you can find a way to fix it. >>>More
1. The toilet tank can be divided into 3 parts:
1. Water inlet component: It is the part that controls the water inflow and outflow, and the shape is mostly the part with a copper rod connected to a large white float. >>>More
It is caused by fire crack Check the pipes on all sides of the toilet, if possible, remove the toilet bowl to see if there is a fire crack at the bottom, sometimes there is a leak at the bottom, of course, if there is a problem with the water tank accessories, it may also cause water leakage all the time >>>More