How to install the toilet properly How to install the toilet bowl

Step 1 Before the toilet is installed, a comprehensive inspection of the sewage pipe should be carried out to see if there is any mud, sand, waste paper and other debris in the pipe.

At the same time, it should also be checked whether the ground of the toilet installation position is horizontal, and if the ground is found to be uneven, the ground should be leveled.

Step 2 Flip the toilet bowl and determine the center on the toilet drain.

At the same time, draw a cross centerline, which should extend to the bottom of the toilet bowl around the feet.

Step 3 Align the reticle line on the toilet bowl with the ground drain outlet and install the toilet bowl horizontally.

At the same time, press the sealing ring tightly and install the anchor screws and decorative caps.

Step 4 Install a special sealing ring on the toilet drain.

Step 5 Drain the water for 3-5 minutes to rinse the pipes to ensure the cleanliness of the water pipes.

Then install the angle valve and connecting hose.

Then connect the hose with the installed tank fitting inlet valve and press the water source.

Step 6 Check whether the water inlet and sealing of the water inlet valve are normal.

Check whether the installation position of the drain valve is flexible, whether there is jamming and leakage, and whether there is leakage to install the filter device of the inlet valve.

1. The toilet should go through strict quality inspection before leaving the factory, such as water testing, visual inspection of appearance, etc., and the products that can be sold on the market are generally qualified, but remember, no matter how big the brand, it is necessary to open the box and inspect the goods in front of the merchant to check whether there are obvious defects and bruises, and whether there is color difference in each part.

2. After buying a toilet with the same wall spacing size and sealing cushion, you can start to install. Before the installation of the toilet, a comprehensive inspection of the sewage pipe should be carried out to see whether there is mud, sand, waste paper and other debris in the pipeline, and at the same time check whether the ground of the toilet installation position is horizontal. Cut the drain short, and if possible, keep the drain 2mm 5mm above the ground as much as possible.

3. Check the water pipe first, and drain the water 3 5 to flush the pipe to ensure the cleanliness of the water pipe; Then install the angle valve and the connecting hose, then connect the hose with the installed water tank fitting inlet valve and connect the water source, check whether the water inlet and sealing of the inlet valve are normal, and whether the installation position of the drain valve is flexible and whether there is any jamming. Test the sewage effect of the toilet, the method is to install the accessories in the tank, fill it with water, try the flushing of the toilet, if the water vortex is very rapid and flush quickly, it means that the water is unobstructed, on the contrary, check whether there is a blockage.

4. In addition, the pit distance must be measured accurately during installation. The pit distance refers to the distance from the center of the drain to the wall behind the water tank, and the error cannot exceed 1 cm, otherwise the toilet cannot be installed. The pit spacing of the drainage method refers to the distance between the center point of the ground sewer hole and the undecorated wall.

After the drainage method, it is necessary to measure its ground distance (refers to the distance from the center point of the drainage hole to the ground). There are generally two kinds of toilet pit spacing: 300mm and 400mm, and there are also 350mm ones on the market. If you want to know the specific distance, you can know the specific data by measuring the horizontal and longitudinal distance from the wall of the toilet to the center of the sewer pipe.