-
Anonymous users2024-01-23To find the cause of the leakage first, if it is the leakage of the water pipe, dig up the pipe to repair the pipe or take another pipe, there is no other way! There is also a kind of water seeping into the brick joint, the waterproofing is not done well or has failed, the water seeps into the other side of the wall, in this case, only the joint is refilled, it may or may not work, because it is difficult to fill the joint really to not enter the water, so it is still leaking, hehe, and there is another situation is the resurgence. More information, better suggestions, free concrete waterproof leakage repair technical consultation, free of charge to avoid today's repair, tomorrow's leakage, every year repair, every year leakage trouble.
-
Anonymous users2024-01-22Steps for secondary waterproofing:
1. Do a good job in hydropower infrastructure projects.
From a safety point of view, it is better to go up the bathroom water pipes and wires than to go down. However, many "guerrillas" are greedy for labor-saving, and water and electricity go to the ground, and even dig grooves and round holes in the bathroom.
2. Clean the base layer and walls.
The house is decorated with waterproof, involving a balcony, a kitchen, a bathroom, but the focus is on the bathroom. First of all, use a small metal hammer to knock on the wall and ground, if you find a "poof" empty sound, it means that there is a hollow drum inside, and you must knock out all the hollow drum parts. Then carefully clean the four wall base and the ground, pull out the nails, clean up the miscellaneous garbage, preferably rinse it with clean water, and then let it dry.
3. Do a good job of rigid waterproofing.
All kinds of sewer pipes in the bathroom can not be changed, try not to change them; In case of change, you must not use cement mortar to fill the pores, and you must plug the leakage king to fill it three times. The most leaky areas in the room are the four sides around the sewer pipes and the corners of the walls, so these key areas should be paid special attention. The ground should also be divided into three blocks around it, and there should be intervals.
In this way, a rigid layer of waterproof armor was worn on the ground. A slope should be made in the threshold of the bathroom, painted high to prevent the water from flowing back into the outside room, and the threshold stone must be slightly plugged with fine cement mortar.
4. Do a good job of the second level of elastic waterproof coating.
After the completion and delivery of the new house, there will be more or less settlement, and after a long time, the hard plugging king elastic coating will be cracked alive due to settlement, thus losing the waterproof effect. Therefore, it is necessary to add a second insurance - elastic waterproofing coatings. Generally, the wall is made moisture-proof first, so that it is more than 1.8 meters.
Because people will splash water on the wall tiles when they take a bath, the gap between the tile molecules is large, and the water molecules can easily enter the wall and penetrate into the wall of the opposite room, resulting in the paint peeling off on the back of the bathroom and the moldy and discolored wallpaper. The wall is moisture-proof, and then the wall tiles are pasted, and then the ground decoration is waterproof.
Then do it again, the bathroom waterproofing is not done well, and it is very troublesome in the later stage. >>>More
You can use JS, polyurethane, Cao Yangbao, Jintang water does not leak, plugging king, South Korea Shuangxiong, the dry area is 300 high, the wet area and the adjacent wall of the bedroom study are also 1800 high, waterproof and do over the threshold, the root of the wall is rounded, the pipe is flanged, the water is removed after the 24-hour water storage test without leakage, and then a layer of mortar protective layer is made, and finally the wall and floor tiles are pasted. A stone base under the door cover is preferred.
Secondary drainage is a drainage method to prevent leakage of water pipes buried in the bathroom and water seepage from the floor to the owner's house downstairs. Because the toilet will leak into the caisson in the case of long-term use, and then accumulate in the caisson, the cement will more or less leak downstairs in the long-term soaking, and the secondary drainage just solves this problem. When decorating, the owner should pay attention to the water pipe laid in the room and it is best to seal it with asphalt, so that even if the interface position is not completely sealed during construction or has been used for a long time, it will not leak. >>>More
Does your contract cost include waterproofing? If there is no decoration company, it can be ignored, but it also means that the decoration company is not responsible for the work, and now there are some waterproof methods of surface conjunctiva, but they are all temporary, and if you want to do it for a long time, you must do it again.
1. To prevent water leakage in the bathroom, it is necessary to do a good job of waterproofing. >>>More