How to replace the toilet seat when it is broken, and will it be troublesome to replace the toilet s

If the toilet seat is broken, the original toilet seat should be removed first, and the specific replacement steps are as follows:

Preparation materials: 1 pair of plastic bearings, 1 pair of screws, 1 pair of lower lock gaskets, 1 pair of lower lock bolts, 1 pair of toilet seats.

1. First of all, confirm that the lower lock parts are complete, as shown in the figure below

>2. Put the screws on the plastic bracket and place them on the toilet installation hole, as shown in the following figure

>3. Put the washer on the plastic nut, on the one hand, press and hold the top of the screw, and turn the nut on the screw from the bottom of the toilet to 9, so that the bracket can also be slightly looser, as shown in the figure below

>4. The two small holes on the cover plate are aligned with the support column and inserted vertically, so that the two sides are bolted and locked in the hand and do not move, as shown in the figure below

>5. Open the cover, press the front button of the cover, remove the cover vertically, and strengthen the screws with a screwdriver to make it fully tightened, as shown in the figure below

>6. Put the toilet lid on the support, as shown in the following figure:

>7. Replace the toilet seat and cover again, and check that the deceleration function of the cover plate is complete.

Do not allow the toilet seat to come into direct contact with abrasive chemicals and cosmetics, as these chemicals can damage the surface of the seat. Do not place hard or heavy objects, such as tank covers, flower pots, buckets, pots, etc., on top to avoid scratches or cracks on the surface. It is recommended to clean the toilet seat with a soft cloth, and do not use strong acid, strong carbon fire decontamination powder, or volatile agents, thinners or chemicals for cleaning, otherwise the surface will be corroded.

In addition, it should not be cleaned with sharp objects such as wire brushes or razors. When the toilet seat is used, it should also be opened and placed gently, and should not collide directly with the water tank, so as not to leave marks that affect the aesthetics or cause it to break. You must pay attention to the places that cannot be approached during the placement process, and there is also the fact that you cannot clean them with chemicals, otherwise the surface will be corroded.

You can use = to remove the screw cap with a wrench and replace it with a new one. Usually the position of the screw cap is not easy to find, either in the light or in the dark. If you are in a dark place, usually on the side of the water tank in the toilet, you need to open the lid and reach in, and grope the position of the water tank above, if there is no accident, you can feel it.

All you need to do is remove and replace the fixing bolts at the back of the toilet, and you need to do it in the opposite direction when installing. In most cases, toilet seats are large and small, and both bolts only need to be adjusted at the time of installation. But don't forget to measure your size:

The distance between the screw holes, the width and length of the toilet seat, can be replaced when a new toilet seat is purchased. For the purpose of saving money, not all toilet seats should be replaced if they have problems, but some are only partially damaged, and some can be repaired without serious problems. You can check the toilet seat first, for example, if it is not very serious, you just repair it, but if you are not repairing it well, you are replacing it, you must unify the model, or you can't install it.