-
Anonymous users2024-01-24First of all, look at the latitude of the city you are in, how many degrees are at the coldest time, and the indoor humidity to decide how to do the insulation.
If it is a northern city, such as the lowest temperature of minus 20 degrees in winter, it is recommended to re-insulation, and the column should also be done, otherwise the sealing is poor, and everything else will be done in vain. This is not like the ceiling insulation and waterproofing, and the balcony will not move after it is basically done, so you have to do it well, otherwise there will be wind in winter, and there will be water leakage and freezing.
Benzene boards, hanging nets, insulation cement, and external cement glue can be considered. You can also consider doing sauna board or anticorrosive wood decoration treatment on this basis, which is easier to take care of than tiles and floors.
Chisel the old "between the upper mouth of the floor drain and the sewer pipe and the floor slab", connect the interface between the floor drain and the sewer pipe, and then use 1:1 cement mortar and 15% of the cement content of the alum stone expansion agent to make up, you can. >>>More
1. Install glass doors to isolate cold air.
Install a glass door between the room and the balcony, not only has good light transmittance, but also can effectively isolate the entry of cold air, play a good role in thermal insulation, and the door can also be completely close to the wall in summer, so as to expand the room area and broaden the line of sight. >>>More
There is no problem with alcohol disinfection, the key is that after you do a good job of waterproofing, he will leak, and now there is that kind of leak-proof glue-like thing that can be coated and there will be no more leakage.
It depends on the specific situation, if the inner side has been pasted and the outer side has not been pasted, you can do thermal insulation on the outside; If the outer side has been pasted and the inner side has not been pasted, you can keep warm on the inner side; If the inside and outside have been pasted, it is not easy to keep warm.
I don't know the location of the wall skin you said, if the wall skin on both sides of the bathroom door falls off from the ground, it means that the waterproof node of the door stone is not done, this is more troublesome, you must remove a few bricks next to the door stone in the bathroom, and then plug the gap between the two ends of the door stone and the wall with mortar, and then brush the side of the door stone next to the floor tile with JS waterproof, and then restore the floor tiles. If the skin of the entire wall root has fallen off, it means that the waterproofing of the root of the bathroom wall is not done, or the additional layer is not done, and it is indeed more troublesome to smash the bricks of the bathroom, and there is a makeshift method to deal with it outside, shovel off the peeling paint, brush 200mm high JS, and then restore the paint and putty, but do not do the root of the wall, leave about 100mm, and stick the tile kicking, which can prevent the putty from absorbing water. If the middle of the wall falls off, the opposite bathroom should be the location of the shower area or bathtub, shovel off the wall skin, brush JS from the outside, and then restore it. >>>More