-
Anonymous users2024-01-24There is no need to change, the oil is gone, or less oil to add a little to the inside, the gears are large, the teeth are also very large, not to the car, the parts are very small, so there is no need to change to add some points inside. Generally, there is a special refueling hand on the bedside box of CNC machine tools, and the 928TE refueling hole is under the display screen in our factory. If not, just open the lid on the bedside box.
-
Anonymous users2024-01-23There is a screw at the bottom of the bedside table to open it to drain the oil. Then remove the lid and pour it inside!! Don't be too full, 1 3 will do!!
Generally, it is changed once every 1 year!! This is a gear-mounted bedside table, and you don't need to refuel if it's not gear-mounted! By the way, the new machine tool should be replaced once every 3 months, because the gears of the new machine tool sometimes fall iron filings, and the run-in period of 3 months will be 3 months.
-
Anonymous users2024-01-22Generally, there will be a reminder, that is, there will be a reminder next to it! It's almost time to change!
1.Carbon deposits can cause insufficient combustion of gasoline and cause the engine to shake. The impact of engine carbon deposition on the car is quite large, first of all, to reduce the engine power, that is, to make the power output uneven and gradually decay, in other words, more and more powerless. >>>More
This can only be analyzed according to the structure of the headbox, the lid on the top of the headbox, there is a sealing strip, to see if the sealing strip is damaged, some numerical control transformation, will remove some transmission gears and forks in the headstock box, these shafts may extend out of the headbox, whether the shaft and the hole are well sealed. >>>More
Short the two wires of the switch.
Are you sure you're talking about tailstock height??
The tailstock height is standardized at the factory, i.e. strictly the same height as the spindle center of rotation. Generally, it is not necessary to adjust. If the old machine is worn out due to the guide rails, it may need to be adjusted. >>>More
The headstock nameplate of the lathe contains the date the machine was manufactured. >>>More