-
Anonymous users2024-01-24It is to control the tailstock, the tailstock is opposite to the spindle, he is coaxial with the spindle, and the center height is the same height as the spindle. The tailstock can be equipped with the top of the tailstock, when the workpiece of the car is longer or the diameter is smaller, in order to reduce the deformation of the workpiece, a clamp and a top are used to process, and the tailstock will be used at this time, and the top is mounted on the tailstock to hold the workpiece tightly.
The tailstock can also be equipped with drill flowers for drilling.
According to you, you may have a hydraulic tailstock, so you can't use the drilling, you can only use it to install the center.
-
Anonymous users2024-01-23Depending on what you describe, it may be the setting of the tip of the tail, which is usually used to assist in clamping the workpiece, or drilling, etc.
-
Anonymous users2024-01-22Hehe, of course, the control tailstock. Don't tell me you don't know where the tailstock is.
There are two types of inclined bed CNC lathe tailstock available: hydraulic and manual. >>>More
You should be talking about soft limit overtravel, because before the hard limit should be the first soft limit. If the soft limit overtravel, you only need to use the hand wheel to swing back. If it is a hard limit overtravel, there is generally a hard limit release switch, press and hold to move back. >>>More
Move the middle carriage to any safe position and modify the parameters.
There is a set of thrust ball bearings, generally in the back. Depending on the model of the lathe, the model of the thrust ball bearing of the tailstock will also be different.
Are you flat bed, and the tailstock is hand-cranked?
If it is to show how much depth is near the top of the shake 1 circle, there is also an angle display, the purpose is basically for drilling, so that you know how much depth you have drilled into, various machine tools are different, some are a circle, and some are 5MM >>>More