How to deal with the details of the structural construction of the toilet drop plate is better

The thickness of the practice can be adjusted with the cushion; Lowers the floor elevation on the thicker side of the method. >>>More

The bathroom slab is generally lowered by about 100, and the surrounding beam height is generally greater than 200, so that even if your floor slab is 100 thick, the slab is still within the support of the beam, that is, the support of the beam or the slab. As for the negative reinforcement, of course, it cannot be penetrated with the adjacent slabs, because the elevation is different and cannot be penetrated, so the negative reinforcement can be considered to extend into the beam.

The beam that passes through the bathroom is lowered by 30, and the beam around the bathroom is not lowered (similar to the edge banding beam), so that it can be connected with the structural floor.

The steel structure toilet should also do a good job of waterproofing the bathroom, and the wall should use waterproof materials. If the floor slab is used for the floor deck plate, the falling part of the bathroom can be made of patterned steel plate and concrete, and the thickness of the floor slab is reduced, which is naturally equivalent to the falling plate. >>>More

Before the bathroom is waterproofed, it is necessary to chisel the ground first, and then backfill and level, and then start to brush the polymer waterproof membrane after backfilling and leveling, and then dry it to a depth of 30 cm in full water, and carry out a closed water seepage test for 48 hours, which is generally done twice to be qualified, so as long as you ensure that these processes are done, there will generally be no problems!