-
Anonymous users2024-01-24Are you talking about tearing it down and using it again? This kind of wallboard is installed, in order to install the wallboard firmly, it must be a little troublesome to dismantle, it should be pried open. Remove the trim first, then pry it off a little bit along the edge, and finally remove the nails from the board.
Hold down the keel with one hand, insert the gusset against the edge seal of the keel with the other hand, and go in with a strong buckle. When the last piece is installed, there is no space for the ceiling, and you can't reach out to the top of the ceiling, so you can only pat the gusset a little hard at the keel position to let it buckle in. Note that it must be an instantaneous impact, otherwise it will cause the entire ceiling to shake and shift if you push it slowly. >>>More
The ceiling fan is tied with iron wire, and the wire is loosened and removed.
Depending on what the top is, some of them seem to be able to go straight up, and some of them need to be taken off first.
First of all, remove a piece of the gusset next to the lamp (with a suction cup or a sticky hook), then remove the lampshade, and then press the tube of the same model. >>>More
The nut is the top wire, you don't need to take it off, as long as it is loose, and then cut it with gas and bake it, and it will come down, which is rusty or greasy.