How to dismantle the outermost part of the furniture three in one connector has been removed

1. Knock the plastic embedded parts into the round hole of the board with the tip facing down, and pay attention to the level of the board after entering.

2. Then screw the screw into the embedded part until you can't see the metal thread part below, be careful not to overtighten it, in case the embedded part trips.

3. Lower and screw into the side plate of the screw and align it into the hole of the plate to be inserted, taking care not to bend the screw.

4. Place the eccentric parts with the cross facing outwards and align them with the screws with the exposed heads.

5. Continue the above steps, rotate and tighten the eccentric parts.

Note: The three-in-one connection reduces the use of adhesives, but there is also a problem that is instability, which requires nailing the back panel of the furniture to be stable. In order to achieve the effect of concealment without leaving gaps, it is necessary to completely knock the embedded parts into the board, so that the three-in-one connector cannot be seen from the outer surface, and it is not easy to have gaps.

This screw is screwed on the side riser and cannot be removed at this time. You need to remove all of these locking nuts associated with the side riser as you would have taken out the lock nut you have now removed, so that the side riser is separated from all the transverse plates, and the screws are on the side riser and then you can unscrew it.

Your metal disc (aka: eccentric wheel) is a button, as long as this eccentric wheel takes two plates, it can be directly separated. Once the plank is separated, the screw can be removed directly with a screwdriver.

From the perspective of the picture, the two boards can be directly separated, and the screws can be easily removed after the board is removed.

Pull it apart directly from side to side to separate the two parts.