How to change the toilet seat

Use a wallpaper knife to dissolve the glass glue and other objects around the toilet, and you can remove it directly.

What toilet seat? Is it a toilet seat?

<>First, we need to disassemble the new wax seal, put its round side facing up, put it on the flange, let the hall collapse just above the opening of the positive chap, and then make sure that the two screws are in place. Next, lift the toilet, put it on the flange and seal, sit on the toilet, let the new seal seal, make sure the bedpan is level, and then reinstall the nut you just removed. Tighten the nut by hand, connect the water supply pipe, open the water valve, and let the water tank hold water.

Finally flush and check for leaks. It is enough to put silicone between the gap between the bedpan and the spike board as needed.

The steps to change the toilet seat are as follows:1Start by turning the water off the toilet bowl by using the faucet or main valve on the toilet.

2.To drain the water in the toilet, you can use the drain valve in the toilet bowl to drain the water3To disassemble the old ring, remove the screws on the toilet base to remove the old ring, and gently remove it.

4.Install the new big drawback ring, install the new circle on the toilet base, and tighten the screw 5Reconnect the water pipe, reconnect the water pipe to the toilet.

6.Turn on the faucet, let the water go to the toilet bowl and check for leaks. 7.

If everything is in order, then the chain is complete. It should be noted that you need to be cautious when changing the toilet seat to avoid damaging the toilet, damaging the water pipe, and causing water leakage and other problems.

Preparation materials: 1 pair of plastic bearings, 1 pair of screws, 1 pair of lower lock gaskets, 1 pair of lower lock bolts, 1 pair of toilet seats.

1. First of all, confirm that the lower lock parts are complete, as shown in the figure below

>2. Put the screws on the plastic bracket and place them on the toilet installation hole, as shown in the following figure

>3. Put the washer on the plastic nut, on the one hand, press and hold the top of the screw, and turn the nut on the screw from the bottom of the toilet to 9, so that the bracket can also be slightly looser, as shown in the figure below

>4. The two small holes on the cover plate are aligned with the support column and inserted vertically, so that the two sides are bolted and locked in the hand and do not move, as shown in the figure below

>5. Open the cover, press the front button of the cover, remove the cover vertically, and strengthen the screws with a screwdriver to make it fully tightened, as shown in the figure below

>6. Put the toilet lid on the support, as shown in the following figure:

>7. Replace the toilet seat and cover again, and check that the deceleration function of the cover plate is complete.