-
Anonymous users2024-01-24If the mobile phone is flooded, you need to perform the following operations:1Disassemble the whole machine and prepare it for use with the appropriate screwdriver.
2.When removing the screen, gently detach the chiplet to which the screen is connected to the motherboard from the motherboard. 3.
Before removing the metal shielding isolation layer, be sure to tear off the network access card and the card slot sticker under the network access card. 4.Take a hair dryer and blow dry, not blowing on the screen for a long time, such a high temperature will destroy the screen 5
Blow the front and back of the motherboard to ensure that there is no moisture left, and try to blow out the water at the earpiece. 6.Put the disassembled phone in a noisy place, preferably for about two days, and then install it.
See if the water inlet switch below has been turned off by your child.
Is the valve open?。。 Is this a new set of drifters??? Press the float on the left to see if it will get into the water, whether the float is too low.
Close the main inlet valve of the toilet bowl and unscrew the connection between the braided hose and the inlet valve with a wrench. Then open the total water inlet valve and observe whether the water inlet is normal. If it is normal, check the inlet valve of the flush toilet, whether there is a filter screen, and whether the filter is blocked. >>>More
There are several reasons why the toilet does not get water: >>>More
If you want to fill more water, you can adjust the height of the water inlet valve of the water tank. >>>More