-
Anonymous users2024-01-246° 200 mm deep outer diameter about 80 inner diameter I forgot that I also operate 20 cars But I don't know it, I'm sorry.
1.Loosen the sleeve fastening handle Shake the handwheel and pull out the sleeve 2Remove the handwheel fixing nut and remove the handwheel. >>>More
It is impossible that you must have changed the wrong gear, played the direction of the wire, the metric system and the imperial system have to change the hanging wheel, some need to change the gear, the direction of the metric system is to the direction of the chuck, unless the wire, but the reverse knife reversal can also pick the wire, you are not this thing to pick the wire experience less jokes, the wrong block knows no.
1. The full taper is determined according to the taper hole of the tailstock sleeve. 6140 is Mohs 5 and 6132 is Mohs 4.
The tailstock is basically marked on the Mohs scale, and you can know how many sizes it is by measuring the size.
After the tailstock is processed, the inner hole of the tailstock can be processed with a special boring bar on the equipped lathe, which can be concentric with the spindle.