-
Anonymous users2024-01-24There should be an empty plastic box inside, when the water level comes up, it will float up, and then connect him and control the felling to lift it up and then close the water, if this is not good to use, you can find a piece of foam smeared plastic bolt on the side to increase buoyancy, if the door is broken, just change it, there are special sales, other problems please find a water worker to see it.
-
Anonymous users2024-01-23Just turn that buoyancy ball position a little bit.
-
Anonymous users2024-01-22Find someone to repair the toilet, you can't fix it, it's generally broken.
This problem should be caused by the toilet is not installed in place, first analyze the problem of slow drainage, one situation is that the pressure of flushing is too small, resulting in the drain also with the weakening of the water flow without pressure, resulting in slow drainage, the second is that the toilet is blocked, this is a small problem, you can clean it up yourself. You can check the pressure of your tap water, if the tap water pressure is normal, it should be the toilet tank. The most critical problem is the small hole under your toilet, this small hole is used to install the toilet, but the user installation is accompanied by another problem is waterproofing, the general bathroom waterproof has been done, before the toilet is installed, so your toilet hole can not be installed by punching holes, (punching holes will destroy the waterproofing). >>>More
You can take a look at my space. There is an article dedicated to this topic. This is a common fault of ordinary toilet inlet valves. It won't take long to use the pants. It is easy to have more than water or no water ingress. >>>More
Toilet leakage can be said to be a more common problem, you must find the cause before repairing, you have to see which part of the water is leaking, and then clean it up, for example, you are leaking water tank, you have to take off the drain machine first, and then clean it up to clean the scale, see if you can, if not, you have to replace it.
Toilets can be cleaned in several ways:
1. Vinegar descaling. >>>More
Generally, the phenomenon that the water has been flowing non-stop after flushing is the rubber plug cover of the outlet or the mouth has scale, you open the water tank cover, and then find the outlet that is the outlet where the water from the water tank flows to the toilet, and check the rubber cover on it to see if there is scale or wear. Generally, it is because of the poor sealing that it causes long-term running water.