-
Anonymous users2024-01-24Four common ways to remodel toilet drains: how to displace toilet drain pipes.
Small-scale shifting: use a special shifter for lifting, there is CM, it is recommended not to exceed 10CM shifter, which will affect the effect of punching and draining.
Large-scale displacement: floor elevation (generally 20CM high), pipe discharge, pipeline should have a certain slope, but the distance should not be too long, the distance is long, the slope of the pipeline should be larger, the ground elevation will increase, and the flushing effect will also be affected. The drain pipe can be connected to the original pothole, or it can be connected to the sewer main with 3 passes.
Perforated displacement of the floor slab: If it is a duplex or a villa, you can make holes in the floor slab and re-take the installation.
Wall-row toilet: If possible, you can choose a wall-row toilet, as long as you build a short wall, the pipe is directly connected to the sewer main.
-
Anonymous users2024-01-23Depending on the situation, if it is changed farther, it must be raised from the platform, the height depends on the distance of the pipeline, and a certain slope and bend are done, which basically has no impact on the future use, that is, the dirt moves slowly, and it is easy to accumulate dirt, which is more water-consuming.
If it is close, then you only need to chisel the floor slab out of a slope to install it directly, and the effect is no problem.
-
Anonymous users2024-01-22To move 30 cm flat, you can ignore the slope of the sewer.
The old pipes are sealed. Run the pipe alone. Direct access to the outfall.
Kitchen sewer oil is easy to block, usually flushed with hot water can be resolved, both economical and convenient, but sometimes it may be that the pipe is not smooth (especially cast iron pipe), fall into the hair and other debris to be dealt with separately, usually to add a strainer at the pool outlet, there are hair and other debris to clean up in time, in case of blockage, the following tools can be used to dredge: >>>More
THERE IS A CERTAIN SLOPE, TRY NOT TO HAVE A TURN, AND USE A 45-DEGREE ANGLE CONNECTION WITH A TURN, AND THE INNER DIAMETER IS NOT LESS THAN 50MM.
1. Do you want to make a wall-mounted cabinet or a vertical cabinet? >>>More
Remove the bricks on the side of the water pipe, groove the water pipe along the circle for 10CM, fill the water pipe along the circle with Yuhong plugging treasure, and carry out arc plastering, and then brush the Yuhong waterproof, and finally paste the brick.