-
Anonymous users2024-01-24The toilet or drain pipe is a little blocked, so that the siphon effect is poor, and the water cannot be sucked out after the toilet is flushed, so that the water left in the toilet bowl increases significantly, making you feel that the amount of water has increased.
-
Anonymous users2024-01-23Obviously, the water pressure is not enough, it may be temporary, and the water slowly flowing out after the impulse becomes smaller, it gives the feeling that there is more water than before, but it is actually the same.
-
Anonymous users2024-01-22There must be something blocking part of the outlet pipe.
In this way, the water pressure is naturally small, and the water level of the water tank drops slowly, resulting in the buoyancy ball can not fall quickly, so the water will continue automatically, and the flushing time is long and water-consuming.
To see if it is the fault I imagined, open the lid of the water tank and look at the water outlet, if the water outlet hose is too bent, this is also the case.
1. Pipeline blockage.
The most obvious reason for the decrease in the suction power of the toilet bowl is that the drainage pipe is blocked, and the pipe, which was originally only the thickness of a fist, has become as thick as a few fingers, and the water will naturally not be able to drain smoothly and quickly, which is manifested in the fact that the suction power of the toilet has become smaller. >>>More
Maybe something is stuffed in the tube, check it.
This is because when the toilet flush button is pressed, the water tank is automatically replenished, and the pressure in the natural water pipe decreases due to the increase in the amount of water outlet. The shower is generally used to adjust the mixed water valve, and after the adjustment is done, the amount of cold water output becomes smaller, and the water temperature will naturally increase!
If the toilet flush is weak or the amount of water is small, we can increase the water power and water volume of the toilet by cleaning the toilet tank, adjusting the toilet inlet valve, and adjusting the water press lever. The toilet has brought a lot of convenience to our lives, but no matter what things have been used for a long time, it is inevitable that there will be some small problems. If the toilet is used for a long time, it may not flush properly or the amount of water may become smaller. >>>More
After flushing, the water level is caused by the slow fall of the cover that closes the opening in the water tank, after pressing the button, the cover is opened, the water is left, the water tank water flows out, the cover will be slowly closed, at this time, the remaining water is still left, to adjust the slider of the height of the cover to be lowered, in addition, on the cover surface, add a lead block or tie a point of steel wire, in order to speed up the speed of the fall of the cover.