-
Anonymous users2024-01-24Your question is not clear, and I don't understand it well. I can only say the following principles:
In principle, the inner wall ring beam should be connected with the outer wall ring beam. The moving position of the local inner wall ground ring beam has little effect on the overall effect of the ring beam, and has little impact on the building safety.
After moving to the new position, the ring beam can still be made according to the design section, and it can be connected with the original inner wall ring beam nearby. The reinforcement at the joint is lapped according to the original design, and the stirrups are configured according to the original design. The concrete at the joint is chiseled, rinsed, and 50 mm mortar is laid first (the amount of sand and cement can be used without adding stones to the concrete), and then the concrete is poured, and the watering and maintenance should be paid attention to after pouring.
If you don't understand the situation, please forgive me if it doesn't match the actual situation.
If the design does not require it, it is good to follow the normal seismic anchorage connection structure. The beam reinforcement passes through the cushion cap, and the cushion cap part should also be equipped with stirrup shear resistance.
Not only the ground ring beam, must be the floor under the ring beam, so that the overall settlement can be more uniform, and the second layer of guest beam can be built on the two or four walls.
The finer the nozzle, the better, and try to hit it at a uniform speed at one time
Flush toilets are installed normally, and then they can be used 24 hours after being filled with silicone. >>>More
Use after 24 hours.
The silica gel can only be used after it has completely solidified, and it usually takes a whole day. Do not shake or drench in water. >>>More