-
50CM40cm from the center of the hole, preferably on the left.
-
You can also make hidden wires, pull to a high place and then make waterproof sockets, but do hidden wires must be done before sticking wall tiles.
-
You just buy a waterproof socket.
In this case, first check whether the power supply voltage is normal, whether the smart toilet wiring is damaged, whether the internal circuit board is wet, and whether there is a fault.
Clause.
1. Preparation for the installation of the flush toilet Before installing a flush toilet, the following 5 preparations should be made: first, check the level of the ground where the toilet is installed; The second point is to check the sewage pipe of the toilet bowl and remove the debris in the sewage pipe; The third is to leave a distance of 2 to 3 mm above the ground at the sewer outlet; The fourth point is to check whether there is any leakage in the water pipe and debug and install the water tank accessories. Finally, it is necessary to test the sewage effect of the toilet, if the water is flushed very quickly, it means that the drainage is not smooth and there is a blockage. >>>More
Harmless, just like a guesthouse.
It's just a panic when flushing the toilet. >>>More
Clause.
1. Preparation for the installation of the flush toilet Before installing a flush toilet, the following 5 preparations should be made: first, check the level of the ground where the toilet is installed; The second point is to check the sewage pipe of the toilet bowl and remove the debris in the sewage pipe; The third is to leave a distance of 2 to 3 mm above the ground at the sewer outlet; The fourth point is to check whether there is any leakage in the water pipe and debug and install the water tank accessories. Finally, it is necessary to test the sewage effect of the toilet, if the water is flushed very quickly, it means that the drainage is not smooth and there is a blockage. >>>More
Pneumatic assisted toilets, larger brands will be available!