-
Anonymous users2024-01-24Yes, as long as the space is enough to put down the toilet, there is a position for installing angle valves on the upper and lower water, and there is a sewer pipe.
Installation method: 1. Take out the pipe plug of the ground drain outlet, check that there is no debris in the pipe, and clean the area around the pipe mouth.
2. The ground on which the toilet is installed must be hard and flat. Floor tiles or other decorative materials should not be paved, and sand and gravel debris should be cleaned up.
3. Before the toilet is fixed. To make it level and calibrate it with a level.
4. There are two options for fixing the toilet:
1) Bolt fixing method: put the toilet in the installation position, draw the contour line of the foot of the toilet on the ground, and draw the bolt hole position through the installation hole on the toilet. After the hole is drilled, insert the detonation bolt, apply adhesive at the joint between the toilet outlet and the ground sewage outlet, put the toilet smoothly, firmly pull the bolt, and finally seal the toilet foot with cement mortar.
2) Cement bonding method: draw the toilet bottom caster corridor line on the ground, lay a circle of 30mm wide and 15mm high cement mortar inward along the contour line, apply adhesive at the junction between the toilet outlet and the ground sewage outlet, wipe the toilet foot, and place it smoothly in the installation position to make it firmly bonded and wipe off the overflowing cement mortar.
5. The cement slurry adhered during construction must be removed before the cement is dry, so as not to be difficult to remove after drying.
6. Connect the water inlet pipe and make sure that there is no leakage.
7. After about one hour, the water is continuously tested several times to ensure that the sewage pipe is unblocked. Test the sewage effect of the toilet bowl by filling the accessories in the water tank, filling it with water, putting a piece of toilet paper in the toilet and dropping a drop of ink, leaving no traces at one discharge, indicating that the water is unobstructed.
8. The toilet should not be used within three days after installation, so as not to affect its stability.
9. If the toilet is cracked due to failure to install according to the above instructions, the responsibility shall be borne by the installer.
It cannot be changed, one of the two calibers is not the same, it is necessary to change small to large, it is easy to block, even if the two calibers are the same, the reservoir is not the same, which is not conducive to urban sewage discharge.
No. The oil will stick to the water pipes and gradually clog the water pipes. This water pipe is special and cannot prevent any other discharge.
Because the toilet sewer is installed in the floor slab and leads to the roof of the bathroom downstairs, if the location is changed, the floor will be damaged, causing water leakage, and there will be many troubles. >>>More
The toilet drain is vertical, and the water is sealed in the toilet, so the odor will not enter the room.
Can you get through the sewer toilet toilet and the pipe is cloggedAs long as there is a dredging machine, everything can be dredged... >>>More