-
Anonymous users2024-01-24Judging from the photo, this water level is a bit high, so adjust the black float downward. The white pipe is just a water supply pipe, which is generally placed in the overflow hole (it can be placed in the water tank).
-
Anonymous users2024-01-23It works, and if it doesn't leak, you win.
Judging from your description, there should be a problem with the piston at the bottom of the tank, which causes the water to not be full, and the water will always be in a state of water inflow. You pat the tank a few times with your hand, and if the water level inside the tank rises after that, it's OK. However, this method cannot fundamentally solve the problem, and completely solve the need to replace the piston.
The principle of toilet water supply is:
1. Use the float to control the water intake, when the water is full, the float floats up and pulls the connecting rod to close the water inlet, and the water stops. >>>More
Reasons why the toilet does not pump water: 1. The water pressure in the home is too low. 2. Confetti is clogged. 3. The filter screen is clogged with scale. 4. The toilet parts fall off. 5. The inlet and outlet valves are faulty. 6. Improper tube design. >>>More
Toilet tank fittings are the core part of the toilet, known in the industry as the "heart of the toilet", which is mainly composed of inlet valves, drain valves and buttons. Roughly, it can be divided into two categories: conjoined and split. Siamese fittings are used for Siamese toilets. >>>More
Is there a water leak? It may be that the sealing effect of the outlet below is not good, and the water has been leaking, and then the water level has been falling to the ruler bend. That's why I kept going to the water. It's good to go to the place where the bathroom is sold to buy a matching family and replace it. >>>More