-
Anonymous users2024-01-24It is best to close and remove the water inlet hose, use a wallpaper knife to repair the original sealant and lift the toilet to see. There must be a gap between the toilet drain and the sewer pipe, and then pile it up a little higher after adjusting it with the plugging spirit, and then sit on it quickly, but first wipe the bottom of the toilet ring dry and coat it with structural glue, it is not suitable to use sealant or glass glue, it is not weather-resistant, and then take the white structural glue around the ring to seal it after doing it, so that the radical cure will not occur again.
-
Anonymous users2024-01-23Possible Causes:
1. The inside of the toilet is broken.
2. The sealing ring is broken.
3. The toilet bowl and the reserved nozzle at the bottom are not aligned.
Hope it helps.
-
Anonymous users2024-01-22It's possible to get it out and take a fresh look.
It is recommended to use neutral silicone glue, which has no odor and good adhesion. For all glass adhesives, the general curing time is about 24 hours. The better quality ones are faster.
It doesn't matter whether the glass glue on the back cover is there (whether it is glued or not) and whether it leaks or not. >>>More
If the sealing balcony structure is stable enough, seal it with neutral silicone glass glue, and if the balcony is not too stable and want to take into account the reinforcement effect, use structural adhesive, note that the two should not be mixed. >>>More
It may be a product problem, so I can only get rid of it and re-play some good ones.
The glass glue should not be beaten point by point, but the entire toilet base should be covered with glass glue all around, and there can be no omission - this is the basic common sense of installing the toilet, otherwise, the smell under the toilet will come up. >>>More