The renovated bathroom is leaking, what to do The bathroom floor tiles have been pried off, and it i

The first thing to deal with is to find the leakage point of the bathroom from the leakage mark downstairs. Then excavate.

Dig into the concrete structure layer. Find the crack and plug it all around with the Leak Plugging Spirit. Prevent water from flowing from other places.

Then brush twice with polyurethane. And remember to make a hole in the downpipe structure plate. Secondary drainage.

Then deal with the downspout waterproofing problem. Dry for a day and then turn off the water experiment. If you don't miss it, you will backfill it.

Which wall of yours is seeping water??? It's rare to dig in the bathroom, just downstairs to fill the grout.

The problem is still in the construction!

The main points may be as follows:

Waterproofing and cement mortar problems! Now the only way is to pull up the bricks and get them all over again!

To redo the waterproofing, you have to test the water to be able to put bricks! Remember: test the waters for at least 24 hours!

The key to your water leakage problem is to find where the leakage point is, if the leakage point (some renovation workers will make the water pipe or drainage pipe under the waterproof layer) under the waterproof layer, it is useless for you to redo it a hundred times.

First find a plumber to test the pressure of your water pipes, first eliminate the problem of water pipes (water pipes), and then check the drainage pipes (floor drains, sewers, etc.), confirm that there is no problem, and then check the waterproofing of the walls and floors of your home, and do no less than 24 hours of closed water test after the waterproof brush is done!

Gradually investigate, generally speaking, the problem of water leakage in the bathroom usually appears in these aspects.

This is more troublesome, you have to clean up all the backfill in the bathroom, because the backfill must be foamed with water, if you don't replace the backfill, it will still seep water until the backfill is dry, and you can check whether the pipe is damaged by the way.

After the treatment, do another layer of waterproofing at the bottom, the wall should also be done, the standard is meters from the ground, the waterproof test is turned off after the waterproofing, if there is no leakage, you can start backfilling, remember, the backfill must not destroy the waterproof layer at the bottom.

After the backfill, it is smoothed with cement mortar, and then a layer of waterproofing is made, remembering that the wall must also be done.

After these are done, you can put up the tiles, the same, without destroying the waterproof layer.

It is also important to pay attention to the area around the sewer pipe and floor drain, which are prone to leakage. The waterproof material is not recommended to be waterproof with mortar, you can choose JCDecaux products with good quality.