The two mouths of the toilet are sealed, don t you deal with it?

This toilet is a toilet in the form of a flush that is mainly used as a siphon. The difference between them lies in the auxiliary flushing, one is jetting, the other is vortex, the former is powerful, the washing time is shorter, and there is a little noise. The latter is softer and longer to rinse, has a longer time to scrub the attachments, and is quieter. >>>More

When decorating, it is necessary to leave a good position, and the center of the sewer hole should be 30 cm from the back wall (after tiling). The center of the sewer hole should be at least 35 cm from the left and right (35 cm from the left and right). Measure that if you are within 10 guilds, you can use a 5 guild or 10 cm toilet shifter to move, use the shifter to put it down and compare, and then dig the floor, at least so that the shifter is level with the ground, and then install the toilet. >>>More

When the toilet leaves the factory, there is a matching special plug that can plug one of them as needed, and a more mouth is equipped with a leather bowl and a 110 sealing rubber ring. If you don't have that thing, you can find a dealer or go to the kitchen and bathroom store to match.

When you suck milk tea, if the straw is smooth and in close contact with the film, is it more laborious to suck? You plug the hole, the inside is sealed, and the air pressure in the air above is getting smaller and smaller after the underwater flow, and the air pressure outside is large, of course the water will be topped, and the effect will definitely not be good. The hole is designed to keep the pressure difference between inside and outside, and the water naturally gravitationally drops.

It should be enough, separate one male and one female.