-
Anonymous users2024-01-24You are talking about the reserved pipe interface, depending on the situation, the kitchen is more than 10cm lower than the counter surface, but not too low, you go to see the hose length of the kitchen faucet, generally 20 to 30cm from the ground is about the same.
The sink in the bathroom is lower than the sink countertop, which is generally 20 to 30cm, and the toilet is about the same height, and the bathtub should be determined according to your bathtub, and the outlet of the shower mixing valve is 1 meter to 1 and a half meters from the ground, and you feel that it is suitable for use.
I mean the height after the floor tiles are paved, generally the floor tiles are 5cm to 10cm higher than the original floor, and the bathroom may be slightly thicker because of the lowest point.
-
Anonymous users2024-01-23Generally, it is 500mm high and 1200mm for the shower, and the water heater depends on the height of the water heater.
1 All a wire "direct", a tee can be, an outer wire directly screwed to the water outlet, connect a tee, and then install a faucet and a rain faucet on each of the two water outlets of the tee (remember to wrap raw tape).
You mean that the water pipe is installed before the angle valve is installed, as long as it is flush with the wall, and you don't need to leave too much.
Hello! The best and most effective way to do this is to reinstall!
If it is a toilet, the water inlet of the water tank should not exceed 20cm high, if it is an ordinary squatting toilet water tank, it is about 45cm high, if it is a high-level hidden wall water tank, please ask professionals to install it, and the general control uses angle valve to control the water intake!
Please have a plumbing dredging company, they have professional tools and relevant experience.