How do you make it big so that the toilet does not splash?

Updated on Toilet 2024-09-09
1 answers
  1. Anonymous users2024-01-24

    1。Put a few pieces of paper in the toilet bowl before you start Remember to be sure to lay it down so that when the poop falls down, it will be held by the paper first There is a good cushioning force The splash will not splash on the fart This is the easiest and most effective way The only drawback is the lack of environmental protection spirit It is a waste of paper resources. . . 2。

    One of the obvious ways to use the toilet without worrying about water splashing on your butt is to do it the continental way, not to sit down, but to use a dangling position on the toilet... To put it simply, it is to raise the height of the buttocks and the water surface of the toilet But with this trick you must have amazing insight and keen judgment Coupled with flexible skills, you have to predict the time when the poop will fall into the water At that moment, quickly raise your hips so that the water will splash Your ass will naturally be safe The disadvantage of this method is that it consumes physical strength and you must maintain a high degree of concentration when defecating The average person hooligan does not recommend you to use this method.

Related questions
8 answers2024-09-09

Teach you how to prevent spilling water when using the toilet.

4 answers2024-09-09

The gas rod valve is not reset, the gas rod valve has a large ball to be able to close with water, after you release the water, the ball falls, and the valve opens to enter the water, so if the water does not enter the water, the structure of the valve reset fails.

1 answers2024-09-09

Bend the wire and insert it red, twist the direction of the hook, cool it with water, and then pull the wire up with the plastic bottle.

3 answers2024-09-09

Wipe the surface of the mirror with a hard soap dipped in water, and then wipe it off with a dry rag to form a protective film, and it will not fog up when you take a bath. Hehe. It's very smart, how can you know if you don't try? Try it, my dear. Hehe, very smart!!

2 answers2024-09-09

Use a wallpaper knife to scrape the glass glue clean, press the new toilet, and use the glass glue to glue along the toilet bowl for a week, and it can be used normally after 12 hours.