-
The front end cover of the tailstock of the lathe is fixed to the sleeve, the rear end cover is to fix the transmission screw, the sleeve is used to install the thimble or drill head, the handle screw is to drive the sleeve to move back and forth, and the handle is used to clamp or loosen the tailstock. The front end cap, rear end cap, sleeve, handle, screw, handle are all cast iron, and the screw is special steel.
-
The front of the tailstock of the lathe is fixed with the sleeve, the rear end cover is fixed with the handle screw, the sleeve is used to install the thimble or drill head, the handle screw is rotated to push the sleeve back and forth to move, the handle is used to fix the tailstock, and the material is of course metal!
The Mohs taper sleeve of the tailstock drill sleeve of each lathe is not necessarily the same, there are Mohs 3, Mohs 2, Mohs 4, 5, and 6. CW6163 or above lathe metric and so on. I can't say for sure how big, the lathe model configuration is not fixed on the Mohs scale or metric cone, to seek truth from facts can not be misleading, I hope to adopt thank you.
Hello! Lathe tailstock.
Lathe tailstock >>>More
1. All the general 6140 tailstock is mold No. 5, you can not fix the flat drill sleeve must be the tailstock mold sleeve wear or need to clamp the drill sleeve wear, in one reason the need to clamp the drill sleeve is defective, the mold is not standard. If it's all new and not worn, wipe the oil off the top.
The lathe tailstock pressure plate can not be used iron plate, this is a strict requirement.
The tailstock of the lathe has the following three functions. >>>More