-
Anonymous users2024-01-23The lathe tailstock pressure plate can not be used iron plate, this is a strict requirement.
-
Anonymous users2024-01-22Normally, I think he uses stainless steel and stuff like that, these metals.
-
Anonymous users2024-01-21I made one of the iron plates I used, and the ones I used pig iron were always broken, and I changed them to three, and it took hundreds of oceans, and I had no choice, so I made one myself, and now it's okay to use.
Hello! Lathe tailstock.
Lathe tailstock >>>More
Are you sure you're talking about tailstock height??
The tailstock height is standardized at the factory, i.e. strictly the same height as the spindle center of rotation. Generally, it is not necessary to adjust. If the old machine is worn out due to the guide rails, it may need to be adjusted. >>>More
There are many reasons for the top of the tailstock of the lathe to resist the machined parts for the processing of the vibrator, mainly in the following aspects: >>>More
No. Taper C Outer cone large diameter basic size D012
The above are the values of the standard Morse taper, we usually use this according to this, you now first need to determine your large diameter size D, and then according to the taper you can calculate the cone angle (note, it is a full cone angle, not a half cone angle). If you still have any questions, you can communicate again. I have answered this question many times, I hope it can help you, I hope you will accept it, thank you. >>>More
1, clamp a round steel as long as possible on the lathe, the tail punches the center hole with the tailstock to install the top top to 2, at the chuck and the tailstock both ends respectively with the same scale on the middle carriage (can also all turn the tool) 3, after the car, the dial gauge is fixed on the large carriage, and the contact of the table is at the horizontal center line of the workpiece 4, the data 5 of the processing surface at both ends is measured with the dial gauge for moving the large carriage plate, the bolt on the tailstock is adjusted, the dial gauge measures the same reading at both ends 6, and it is better to repeat the above-mentioned method once more reliable.